火灾可燃气体检测系统的设计.docVIP

PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT II 摘 要 一氧化碳报警器是利用A/D转换原理，将模拟量转换成数字量，并用数字的形式在显示屏上显示出来。数据的精度由A/D转换器决定，本设计用模数转换器ADC0809对模拟信号进行转换，单片机STC89C51为控制核心，来完成对数据运算和处理，最后驱动LCD1602显示屏显示数字信号，并将数值与设定值做比较，以控制声光报警和继电器是否吸和，系统手动设定上下限报警值。本设计的程序由keil软件进行编译和调试，keil中有C编译器，宏汇编，库管理等的完整开发方案，由集成开发环境把他们组合在一起。 keil软件和proteus软件一起使用，用Proteus仿真软件所设计的接口电路，通过keil软件进行编译，编译完后会自动生成一个HEX格式的文件，把它加载到Proteus中便可进行仿真。用Proteus软件完成电路分析和模拟仿真。Proteus运行环境为Windows系统，可以进行仿真、分析模拟器件和集成电路，同时具有单片机和SPICE的功能，功能强大，硬件少，形象直观。 本页为中文摘要样版关键词：STC89C51 ADC0809 LCD1602 本页为中文摘要样版 Abstract Carbon monoxide alarm?is the use of A/D?Carbon monoxide nversion,?the?analog quantity?into digitalquantity?to be measured,?and?displays the measured?results?in digital form.?The accuracy of the data?is determined by the?A/D Carbon monoxide nverter,?the design?with the ADC0809?Carbon monoxide nversion of analog?signal,?MCU STC89C51 as the Carbon monoxide ntrol Carbon monoxide re,?the Carbon monoxide mpletion of?the task of?data?operation and processing,?finally?to drive LCD1602 display?digital signal,?and thenumerical value?with the set value?Carbon monoxide mpared?to?the Carbon monoxide ntrol,?sound and light alarm?and?relay is?absorbed?and.?Manually set the?alarm?valuesystem.?The design of the?program?Carbon monoxide mpiling and debugging?by keilsoftware,?C?keil?Carbon monoxide mpiler,?macro assembler,?Carbon monoxide mplete development program?management,?by the integrated development environment?and put them?together. Keil?software and Proteus Software?Carbon monoxide mbined with?Proteus simulation software,?the interface circuit?design based on?keil software,?will beinCarbon monoxide rporated into the?Carbon monoxide mpiler,?after the Carbon monoxide mpiler?automatically generates an?HEX file,?it?can be?loaded into the Proteus?simulation.?The circuitanalysis and simulation?is Carbon monoxide mpleted by?Proteus software.?Proteus?runs on Windows,?simulation?and?analysis?of analog devices and integratedcircuits,?with?MCU and SPICE?