塑料笔杆的注塑工艺及模具设计论文.doc

湖北汽车工业学院毕业设计论文 PAGE 摘 要 该说明书是对管衬进行注塑模设计，其间涉及到材料的分析，它决定了该设计可用到强制抽芯以解决球型芯中间大，两头小，难出芯问题。该设计大体上是这样的：采用SYS-30立式注塑机，一模两件结构，分型面设在下表面，侧浇口进料，两次抽芯机构（斜导柱侧抽芯和扇形推杆顶出强制抽芯）。其中还涉及到镶块，思路看似清晰，但各种结构间的关系和力的作用是难点和重点。 关键词 注塑模 型芯 镶块 斜导柱 ABSTRACT The manual is to design the injection molding of tube, involving analysis of material among them, it determines that the design can use force releasing core in order to solve ball type core, which the both ends are smaller than the middle, and it is difficult that the core question happen. The design adopts SYS-30 vertical moulding plastics machine, a mould and two pieces of structure, andit is on the bottom to set up the surface grouping, side runner charge-in, two releasing core organization (angle pin side release core and fan- shaped push the thing by force releasing the core) , and it includs using the inserts . The thought seems to be clear, but the function related to and strength among various kinds of structure are difficult point and focal point. Key words ： injection molding core insert angle pin 湖北汽车工业学院毕业设计论文 目 录 TOC \o 1-3 \h \z HYPERLINK \l _To第一章 概 论 PAGEREF _To\h 1 HYPERLINK \l _To1.1 课题背景及意义 PAGEREF _To\h 1 HYPERLINK \l _To1.2 本课题及相关领域的国内外现状及发展 PAGEREF _To\h 2 HYPERLINK \l _To1.2.1 我国塑料模具工业的发展现状 PAGEREF _To\h 2 HYPERLINK \l _To1.2.2我国塑料模具工业和技术今后的主要发展方向 PAGEREF _To\h 3 HYPERLINK \l _To1.2.3国外的注塑模的发展情况 PAGEREF _To\h 3 HYPERLINK \l _To1.3 注塑模设计的有关介绍 PAGEREF _To\h 4 HYPERLINK \l _To1.3.1注塑模基本组成 PAGEREF _To\h 4 HYPERLINK \l _To1.3.2注射模的设计程序 PAGEREF _To\h 5 HYPERLINK \l _To第二章 工艺分析 PAGEREF _To\h 6 HYPERLINK \l _To2.1 材料分析 PAGEREF _To\h 6 HYPERLINK \l _To2.1.1 材料简介 PAGEREF _To\h 6 HYPERLINK \l _To2.1.2工艺参数 PAGEREF _To\h