PIM稀疏模式为什么不与静态路由一起使用对HSRP地址.PDFVIP

PIM稀疏模式为什么不与静态路由一起使用对 HSRP地址？ Contents Introduction Prerequisites Requirements Components Used Conventions Network Diagram 配置 Related Information Introduction 本文解释为什么没有转发组播信息包，当您配置静态路由对独立于协议的组播(PIM)时稀疏模式相邻 的热备份路由协议(HSRP)地址。 Prerequisites Requirements 本文档的读者应掌握以下这些主题的相关知识： HSRP PIM稀疏模式 Components Used This document is not restricted to specific software and hardware versions. Conventions 有关文档规则的详细信息，请参阅 Cisco 技术提示规则。 Network Diagram 在以上图，路由器2和3谈在子网的HSRP，并且路由器2是活动路由器。路由器1， 2，并且 3谈增强的内部网关路由选择协议(EIGRP)和路由器4有静态默认路由对HSRP虚拟地址。 配置 路由器 1 路由器 2 Current configuration: Current configuration: ! ip multicast-routing ! ! ip multicast-routing ! ip dvmrp route-limit interface Loopback0 20000 ip address 0 ! 55 ! no ip directed-broadcast interface Ethernet1 ! ip address interface Ethernet0 no ip address no ip redirects no ip directed-broadcast ip pim sparse-mode shutdown standby 1 priority ! 110 preempt interface Ethernet1 standby 1 ip ip address no ip directed-broadcast ! ip pim sparse-mode interface Serial1 ! no ip address interface Serial1 encapsulation frame- no ip address relay no ip directed-broadcast ! encapsulation frame-relay interface Serial1.1 ! point-to-point interface Serial1.1 point-to-point ip address ip address 52 52 ip pim sparse-mode no ip directed-broadcast frame-relay ip pim s