MAZAK 刀库原点设定.pdfVIP

Tool Magazine Home Position Adjustment(M640M) (刀库原点调整 M640M 系统,) The magazine servomotor is controlled by MR-J2-CT driver which can adjust the zero point (PK1) position by changing the position data. The procedure below describes how to set it using the ORIGIN SET in the zero-point adjustment. （刀库伺服电机使是被通过改变位置数据能调整零点位置的MR-J2驱动器控制， 下面描述的是在原点调整中怎样‘原点设定’） 1. Set the PLC parameter R2107 bit F to 1, and turn off the power. (The magazine home return becomes validated.) （更改参数R2107 位F为‘1’，开关机两次）（刀库原点回归有效） 2. Make sure that the tool shifter is either in the magazine side or the ATC side. （确认刀具转换机构位置，刀库侧或换刀手臂侧） 3. Turn on the power and select the magazine pocket PK1. （选择‘1’号刀袋在换刀位置） 4. Press the MACHINE MENU key while the CNC is in the manual mode to display the machine menu, and then press the MAGAZINE SET.MENU key in the machine menu. （手动模式按下MACHINE 菜单后选择MAGZINE SET. MENU） 5. Press the ORIGIN MODE menu key while holding the MF1 key pressed. (同时按下MF1和ORIGI MODE 菜单) * This operation makes the magazine rotation slow when the FORWARD and REVERSE buttons on the magazine operation panel and the MAGAZINE JOG CW and MAGAZINE JOG CCW menu keys in the machine menu are used. （此操作可以使刀库用MAGAZIEN JOG CW/CCW菜单 和 FORWARD/REVERSE 按键缓 慢旋转） 6. By using the FORWARD/REVERSE button on the magazine operation panel and the MAGAZINE JOG CW/MAGAZINE JOG CCW menu key in the machine menu, turn the magazine in order to set the magazine PK1 to the correct ATC position. （用刀库操作面板按键FORWARD/REVERSE 和MAGAZINE JOG CW/CCW 菜单旋转刀 库使‘1’号刀袋到合适的换刀位置） * This position agrees with the center position of the tool shifter on the magazine side. （此位置与刀具转换机构在刀库侧的中心位置一致） 7. Press the ORIGIN SET key while holding the MF1 key pressed. The menu begins blinking. （同时按下MF1和ORIGIN SET 菜单，OR