辐射冷却面板应用於穿透式电子显微镜试验室空调系统之规划与探讨.PDFVIP

輻射冷卻面板應用於穿透式電子顯微鏡實驗室空調系統之規劃與探討 The Design and Application of Radiant Cooling Panel Air Conditioner System in a Transmission Electron Microscope （TEM ）Laboratory 卓清松 莫鳳民 鄧敦平 王偉儒 C.S. Tso, F.M. Mo, T.P. Tng, W.R. Wang 國立台北科技大學冷凍空調研究所 摘 要 輻 射冷卻面板 空調系統應用於穿 透式電子顯微鏡實驗室 之研究 ，最 主要目的是 希望能克服氣 流及 噪 音的干 擾 ，以及如何能 達到環境穩 定的溫度需 求。在實驗研究方面得 知輻射冷卻面板入口水溫在 15 ℃與 17℃的兩種運轉模式下比較結果 ，對於溫度場的穩 定度之表現平均均在±0.6℃~0.8℃左右 ，但仔 細觀察前 者仍優於後者 ，然而畢竟被動式的氣流 對負載的變 化剛開始的反應速 率較緩慢 ，因 此本研究 設計搭配 多孔性材質風管 送風下 ，進一步實驗結果明顯得到更佳及 快速的穩定 效果 。總結輻射 冷卻面 板 空調系統可減少在低溫 、低效率的 情況下使用 ，它運用在本實驗室環境控制之下溫, 度場的表現確實 能符合設計需 求。 關鍵詞 輻射: 冷卻面板、自然對流、穿透式電子顯微鏡 ABSTRACT The major objective of application of “Radiant Cooling Panel” on HVAC System for Transmission Electron Microscope （TEM ）Lab is expected to overcome interference of airflow and noise. Another goal of this research is to find out how to achieve an environment with stabilized temperature. By providing entering water temperature at 15℃or 17℃ separately to the Radiant Cooling Panel for testing, it was found that temperature field could be stabilized at around ±0.6℃~0.8℃. Detailed comparison also shows that lower entering water temperature is preferred. The response on change of load or temperature field is slower at the initial stage due to natural convection effect, porous materials were then used on supply air ducts to improve stabilization time. It was concluded that the Radiant Cooling Panel could be applied on HVAC system to prevent low temperature / low efficiency operation. This meets the requirement of the Lab on temperature field . Keywords: radiant panel, natural convection, transmission electron microscope(TEM) 一、前言 microscope, TEM ）是專門研究與 分析材料結構