毕业论文-车用扭杆结构强度分析研究.docx

中北大学2017届毕业设计说明书 毕业设计说明书 车用扭杆结构强度分析研究 学生姓名： 学号： 学 院： 机械与动力工程学院 专 业： 车辆工程 指导教师： 2017 年 06 月 车用扭杆结构强度分析研究 摘 要 随着技术水平的提高，扭杆作为受力杆件在当今汽车设计中应用越来越广泛。本文通过对车用扭杆的结构、种类及特点，以及国内外对扭杆研究现状的分析。针对抗侧滚扭杆的结构强度和疲劳寿命进行分析研究。采用SolidWorks软件对扭杆进行建模，采用ANSYS分析软件，采用有限元分析方法对车用扭杆强度进行有限元分析。通过对比有限元分析结果与传统力学分析结果，验证传统分析方法的可靠性。证明本次分析结果是正确的。最后对车用扭杆的加工制造工艺也进行了分析。 关键词：SolidWorks，ANSYS，扭杆，有限元，制造工艺 Analysis on The Strength of Automotive Torsion Bar Abstract Nowadays,with the improvement of the technical level,torsion bars are becoming more and more widely used in automobile design.In this paper,the structural strength and fatigue life of the anti roll torsion bar are analyzed and studied after analyzing the structure,types and characteristics of automotive torsion bar, and the research status of torsion bar at home and abroad.SolidWorks software is used to model the torsion bar. ANSYS analysis software is adopted to analyze the strength of the torsion bar by finite element method.By comparing the results of finite element analysis with the traditional mechanical analysis,the reliability of the traditional analysis method is verified.It is proved that the analysis result is correct.Finally,the manufacturing process of the automotive torsion bar is also analyzed. Keywords: SolidWorks, ANSYS, Torsion bar, Finite element, Manufacturing process PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT III 目 录 TOC \o 1-3 \h \u HYPERLINK \l _Toc485114481 1 引言 PAGEREF _Toc485114481 \h 1 HYPERLINK \l _Toc485114482 1.1 车用扭杆概述 PAGEREF _Toc485114482 \h 1 HYPERLINK \l _Toc485114483 1.1.1 扭杆的种类 PAGEREF _Toc485114483 \h 1 HYPERLINK \l _Toc485114484 1.1.2 各扭杆的作用 PAGEREF _Toc485114484 \h 1 HYPERLINK \l _Toc485114485 1.2 国内外研究情况 PAGEREF _Toc485114485 \h 3 HYPERLINK \l _Toc485114486 1.2.1 国内外扭杆结构特点 PAGEREF _Toc485114486 \h 3 HYPERLINK \l _Toc485114487 1.2.2 国内外的研究情况 PAGEREF _Toc485114487 \h 3 HYPERLINK \l _Toc485114