基于单片机的结晶器液压振动波形发生器的设计--上位机部分毕业设计说明书.doc

内蒙古科技大学毕业设计说明书（毕业论文） 摘 要 在现代钢铁企业中，结晶器是连铸工艺的关键设备，为保证连铸生产的顺利进行，需要通过一个振动装置使结晶器按一定的规律振动。目前国外已广泛采用了先进的液压式振动，而国内对此研究甚少。 结晶器液压振动系统，可以很方便地产生各种振动规律，实时显示并根据拉坯速度修改振动参数。连铸机结晶器振动波形发生器从总体上分为两个部分：上位机部分和下位机部分，本设计为上位机部分。 利用微软公司开发的Visual Basic软件，设计了结晶器液压振动波形监控界面。将下位机产生的波形信号通过串行通信方式传送给上位机，可以通过该监控界面显示，将波形数据直观地展现出来。同时，可通过键盘远程修改上位机显示的波形参数。 关键词：结晶器；波形发生器；串口通信；Visual Basic 内蒙古科技大学毕业设计说明书（毕业论文） The design of mould hydraulic vibration waveform generator based on SCM-upper PC part Abstract In the modern iron and steel enterprises , continuous casting is the key equipment of steel-making process. And in order to ensure the smooth progress of continuous casting production , it is essential to install a vibration device ,thus continuous casting can vibrate according to a certain law. Currently abroad has widely used advanced hydraulic vibration ,but little studied on it in the domestic .In light of this situation ,the hydraulic vibration waveform generators of continuous casting were studied in this thesis. The mould hydraulic vibration system can conveniently generate kinds of vibration laws and real-timely show and modify the vibration parameter according to the speed of the casting. The hydraulic vibration waveform generator of continuous casting mould is divided into two parts ;the upper part and the lower part of generator .The paper takes the upper part of generate for study object . Using the Visual Basic software that developed by Microsoft ,I designed a interface of waveform detect .Then send the waveform signal generated by the lower part to the upper part through series communications scheme .And then these signals will analysis and mould every parameters such as amplitude and frequency through the waveform detect interface.Thus, waveform data can be directly to present. At the same time，it can modify the waveform parameter of the upper part showed and control the vibrate form of the mould remotely. Key words: Mould ; waveform Generator ; Serial communication ; Visual Basic 内蒙古科技