洛阳石化硫回收装置扩能与富氧化改造研究-化学工程专业毕业论文.docxVIP

ABSTRACT To improve the processing capacity of the sulfur recovery unit, the formation process and calculation method were studied. According to relevant literature combined with practical, used use EXCEL, PROII software, prepared the sulfur recovery unit process calculation table, the completion of the sulfur recovery unit acidic gas furnace equipment in a not rich oxygen and rich oxygen cases technical calculation, combined with my company rich oxygen source and the actual, puts forward the rich oxygen modification scheme. Specific content as follows: The sulfur recovery unit process calculation method was studied .Through the calculation of chemical equilibrium constant, according to the reaction around enthalpy balance, the balance of transformation was computed, the balance temperature was calculated. Using this method, the acidic gas furnace was calculated. The results and literature value deviate about 0.9%.The research shows the calculation method are accurate, meet the engineering calculation requirements. Four conditions in air was Calculated to the sulfur recovery unit. According to the sequential patterns, each of sulfur recovery unit design calculation, the various equipment and material composition and production load was calculated. In normal load and 110% under the load, the equipment was basic satisfied; Production load more than 110%, the equipment appear super design load phenomenon; Level 1 condenser and exhaust gas heating furnace to design load can be 200%. The sulfur recovery unit in rich oxygen 40%, 150% production load conditions was calculated and identified various equipment material composition and production load. Calculation results show that in the rich oxygen conditions, the device can reach 150% of the production load. The rich oxygen transformation engineering problems was Studied at our company. For rich oxygen modification in our company, 150% of production load namely 60× 103 t/a, acid gas combustion furnace does