基于DSP的FIR低通滤波器设计毕业设计论文.doc

本科毕业设计 基于DSP的FIR滤波器设计 PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT II 摘要 随着科学技术和信息处理的高速发展，目前数字信号处理已经在电子信息、无线电、自动控制等得到广泛应用。本文基于DSP完成了FIR低通滤波器设计。介绍了FIR数字滤波的特点和设计方法以及FIR低通滤波器的设计过程。主要采用了布拉克曼（Blackman）窗函数实现FIR低通滤波器，并给出了MATLAB仿真结果。最终基于DSP在TMS320VC5009平台上用C语言编程在CCS软件上实现了通带边缘频率10KHz，阻带边缘频率22KHz，阻带衰减75dB，采样频率50KHz的FIR低通滤波器。 关键词：FIR低通滤波器 DSP CCS 窗函数 MATLAB DSP-based FIR Filter Design Abstract With the rapid development of science and technology and information processing, the current digital signal processing has been widely applied in electronic information, radio, automatic control.Based on DSP completed the FIR low-pass filter design. Describes the characteristics and design method of FIR digital filter and FIR low-pass filter design process.The main use of Blackman (Blackman) window FIR low-pass filter function implementation, and gives the MATLAB simulation results. Ultimately based on DSP using C language programming on the CCS software platform on TMS320VC5009 filter passband edge frequency 10KHz, stopband edge frequency 22KHz, stop-band attenuation 75dB, FIR 50KHz sampling frequency low-pass. Keywords: FIR low-pass filter window function MATLAB DSP CCS 目 录 TOC \o 1-3 \h \u #include ICETEK-VC5509-EDU.h #include scancode.h #include math.h #define FIRNUMBER 25 #define SIGNAL1F 1000 #define SIGNAL2F 4500 #define SAMPLEF 10000 #define PI 3.1415926 float InputWave(); float FIR(); float fHn[FIRNUMBER]={ 0.0,0.0,0.001,-0.002,-0.002,0.01,-0.009, -0.018,0.049,-0.02,0.11,0.28,0.64,0.28, -0.11,-0.02,0.049,-0.018,-0.009,0.01, -0.002,-0.002,0.001,0.0,0.0 }; float fXn[FIRNUMBER]={ 0.0 }; float fInput,fOutput; float fSignal1,fSignal2; float fStepSignal1,fStepSignal2; float f2PI; int i; float fIn[256],fOut[256]; int nIn,nOut; main() { nIn=0; nOut=0; f2PI=2*PI; fSignal1=0.0; fSignal2=PI*0.1; fStepSignal1=2*PI/30; fStepSignal2=2*PI*1.4; while ( 1 ) { fInput=InputWave();