矿井提升机论文.doc

PAGE II 摘 要 矿井提升机是矿山重要设备,肩负着矿石、材料、人员运输责任。传统的矿山机械和电气控制系统采用绕组转子串联电阻调速,控制电路复杂、效率低、能耗大等缺点。所以提升控制系统的研究具有重要的现实意义。 本文针对当前矿井提升机电控系统的现状，在可编程序控制器(PLC)和变频器的基础上，研究并设计了一套可靠性高、控制性能良好的矿井提升机控制系统。分析了PLC和变频器的性能特点并进行选型，论文根据矿用提升机的运行特性要求，对变频器和PLC进行选型，最终选定西门子公司的S7-200 PLC和ABB公司的ACS800变频器。对系统的软、硬件进行设计，最后进行系统集成和调试,选用MCGS组态软件来完成矿井提升机控制系统的上位监控。 关键词 矿井提升机 变频器 PLC MCGS ABSTRACT Mine hoist is the most important equipment in mines, is shouldering the ore, materials, personnel transportation liability. Traditional mine mechanical and electrical control system adopts winding rotor series resistance speed control, poor control circuit is complex, high performance, high failure rate, power consumption, low efficiency of faults, so the mine hoist control system Research has practical significance. This article in view of the current status of mine mechanical and electrical control system, the programmable controller (PLC) and frequency converter, on the basis of research and design a set of high reliability, good control performance of mine hoist control system. Analyzes the performance characteristics of PLC and frequency converter and selection, the paper according to the requirements of the mine hoist running characteristics, the selection of frequency converter and PLC, finally selected Siemens S7-200 PLC and ABB ACS800 inverter. The system hardware and software design, finally carries on the system integration and debugging, use the MCGS configuration software to complete the upper monitoring of mine hoist control system. Key words Mine hoist Inverter PLC MCGS 目 录 TOC \o \h \u \h \u HYPERLINK \l _Toc26667 Abstract ( in Chinese ) l _Toc29900 Abstract ( in English ) l _Toc18057 Chapter 1 Introduction l _Toc23907 1.1 Introduction l _Toc23510 1.2 Research status at home and abroad l _Toc8685 1.2.1 The foreign research situation of the elevator l _Toc11269 1.2.2 The research status of domestic elevator l _Toc22162 1.3 System technical requirements l _Toc8864 1.4 Speed ele