投射式LED汽车近光灯自由曲面透镜设计.docxVIP

第41卷第9期 第41卷第9期 红外与激光工程 2012年9月 V01．4l NO．9 Infrared and Laser Engineering Sep．2012 投射式LED汽车近光灯自由曲面透镜设计 王 洪1,2，王丽君。，叶菲菲1，黄华茂1，罗婉霞。 (1．华南理工大学理学院广东高校半导体照明工程研究中心，广东广州510640； 2．School of Materials ScienceEngineering，Georgia Institute of Technology，Atlanta 30332 USA； 3．广州广日电气设备有限公司，广东广州511447) 摘 要：根据LED光源的发光特性，设计了一种由椭球反射器、挡板和自由曲面透镜所组成的投射 式LED近光灯系统。基于非成像光学理论，建立了LED光源经椭球反射器后的出射光线角度与照明 平面上坐标的对应关系，结合折反射定律计算透镜自由曲面上的点坐标，通过建模软件将坐标点拟合 成曲面实体而得到自由曲面透镜模型。采用蒙特卡洛光线追迹法进行仿真，结果表明：其配光结果完全满 足GB4599—2007标准，而且体积小，视野广阔，边缘区域光能也较高，光线利用率达到95．92％。 关键词：LED近光灯； 投射式系统； 自由曲面透镜 中图分类号：0434．19 文献标志码：A 文章编号：1007—2276(2012)09—2463—05 Design of LED headlight low-beam freeform lens based on proj ector system Wang Hon919，Wang Lijunl，Ye Feifeil，Huang Huama01，Luo Wanxia3 (1．Guangdong Engineering Regearch Center for Solid State Lighting，School of Science，South China University of Technology， Guangzhou 510640，China；2．School of Materials Science and Engineering，Georgia Institute of Technology，Atlanta 30332 USA； 3．Guangzhou Guangri Electrical Equipment Company Limited，Guangzhou 511447，China) Abstract：According to the features of LED light projector low—beam system，which consisted of the ellipsoidal reflector，baffle and freeform lens，was presented．Based non—imaging optics theory， the correspondence between the angle of the light reflected by the ellipsoidal reflector and the coordinates of point in the target plane was established．The freeform lens point coordinates calculated according to the correspondence of reflection and refraction laws was fitted to surface entity by mechanical modeling software，and was impoged into optical software to be simulated by Monte Carlo ray tracing method．The results show that light distribution of lens fully satisfied GB4599-2007 standards，and the system has small size，broad vision，high light of edge regions，and the efficiency of incident rays is 95．92％． Key words：LED low—beam；projector system；freeform lens 收稿日期：2012—01—12； 修订日期：2012一02一