酒泉肃州区职教中心综合实训楼强电电气设计.docVIP

兰州交通大学毕业设计（论文） 兰州交通大学毕业设计（论文） - PAGE IV - - PAGE I - 摘　　要 本设计为酒泉肃州区职教中心综合实训楼强电电气设计。设计内容包括：照明平面设计和系统设计、配电系统设计、等电位联接及防雷与接地系统设计。 在照明系统的设计中，结合该建筑的结构、功能等特点按有关电气照明设计规范确定各房间的照度，采用单位容量法进行了照度计算。对于照明配电系统，利用需用系数法对相关照明设备的负荷和照明线路的电流进行了计算，并参考有关建筑照明设备手册对导线、开关、插座、照明配电箱等设备做了选型，依据以上设计绘制了实训楼的照明平面图、照明系统图以及配电系统图。按三类防雷建筑物进行防雷设计，并设计总等电位联结系统。 设计符合国家相关技术规程规范要求，设备选型合理，满足使用功能要求，能较好地指导施工。 关键词：照明；负荷计算；供配电系统；防雷 - PAGE III - Abstract The design is entitled with tower of high voltage electrical on the comprehensive training center located in Suzhou district of Jiuquan. The design contents include lighting graphic design and system design, and the power distribution system design In lighting system design, combined with the building of the structure, function, and the illumination requirement which is ruled in lighting design specification, the method of unit capacity for calculating illumination is used. For lighting distribution system, lighting-related load and line current are calculated based on needed coefficient method, at the same time, referring to the relevant manual of architectural lighting equipment, the selection of wires, sockets, circuit breakers distribution boxes and other lighting equipments have been finished, based on the above, draw the lighting system plan, floor plan and power distribution system design. Lighting protection with the 3rd level is designed in accordance with specifications, and together local equipotentialconnection is designed. The overall design accords with the relevant technical regulation requirements. Equipments selection is reasonable so as to better meet the applicable functions, and be able to better guide the construction. Key Words：Lighting，Load calculation，Supply and distribution system，Thunder protection 目 录 TOC \o 1-3 \h \z \u 摘　　要 I Abstract II 目 录 III 1 绪论 1 1.1 工程背景 1 1.2 设计范围 1 1.3 设计依据 1 1.4 设计目标 1 1.5 本文的主要工作 2 2 照明平面图 3 2.1 照明平面图设计 3 2.1.1 照度确定 3 2.1.2 光源和灯具的选择 4 2.1.3 室内负荷的计算 4 2.2开关