电缆线路施工检验.docxVIP

电缆管配置及敷设 Cable pipe configuration and laying 工序 Process 检验项目 Check items 性质Property 质量标准 Quality standard 检验方法和器具Inspection method and instrument 电缆管制作 Cable pipe fabrication 外观检查appearance inspection 金属管metal pipe 内表面Inner surface 光滑，无毛刺smooth，no burrs 观察检查visual check 外表面Outside surface 无穿孔、裂缝、显著的凹凸不平及锈蚀no hole，crack，obvious unevenness or rust 塑料管plastic pipe 敷设温度laying temperature 按设计规定as per the design stipulation 按图纸检查并检查出厂合格证check as per the drawing and check the factory certificate 管材强度pipe strength 切断口（管口）nozzle 光滑smooth 观察检查visual check 弯曲部分bending section 无裂缝及显著的凹瘪no crack or obvious concavity 每根电缆管的弯头数No. of each pipe bending elbows 一般弯头common elbow ≤3个 not more than 3 观察检查visual check 直角弯头right angle elbow ≤2个 not more than 2 弯曲半径bending radius 主要primary 与所穿电缆弯曲半径匹配suitable for the cable bending radius 用样板检查check with the sample 电缆管弯扁度cable pipe bending flatness degree 不大于1/10电缆管外径not bigger than 1/10 of the cable pipe OD 用尺检查check with the tape 电缆管检查 Cable pipe inspection 电缆管内径ID of the cable pipe 按设计规定，且不小于1.5倍电缆外径as per design stipulation, and not less than 1.5 times of the cable outside diameter 用尺检查check with the tape 管内畅通检查non-obstruction check 主要primary 光滑，无积水，杂物smooth, no seeper or sundries 用0.85倍管内径拉线球检查check with the bracing wire ball(0.85 times pipe inside diameter) 敷管 Pipe laying 路径method 按设计规定as per design stipulation 对照图纸检查check comparing with the drawings 明敷exposed laying 单管敷设single pipe laying 横平竖直horizontal and vertical 观察检查visual check 排管敷设pipe bundle laying 管口高度nozzle elevation 一致identical 观察检查visual check 弯曲弧度bending radian measure 观察检查visual check 引至设备的管口位置lead to the nozzle of the equipment 便于电缆与设备连接，并不妨碍设备拆装和进出convenient to connect the cable and the device, not obstruct the equipment dismounting and passing 观察检查visual check 与热力管道，热力设备之间的净距the net distance between pipe and the heating pipe, heating equipment 平行敷设parallel laying 主要primary ≥1m，不宜敷设于热力管道上部≥1m, not good to lay above the thermal pipes 用尺检查check with the tap