ANSYS120官方培训教程 Fluent Workshop6-Modeling of Catalytic Convertor.pptVIP

WS6: Catalytic Converter WS6-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. April 28, 2009 Inventory #002601 Workshop Supplement WS6-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. April 28, 2009 Inventory #002601 Introductory FLUENT Training Workshop 6 Modeling of Catalytic Convertor Introduction A workshop to demonstrate how to model porous media in FLUENT Workshop models a catalytic convertor. Nitrogen flows in though inlet with an uniform velocity 22.6 m/s, passes through a ceramic monolith substrate with square shaped channels, and then exits through the outlet. Substrate is impermeable in Y and Z directions, which is modeled by specifying loss coefficients 3 order higher than in X direction Ceramic Monolith Substrate Inlet Outlet Starting Fluent in Workbench Open the Workbench (Start Programs ANSYS 12.0 ANSYS Workbench) Drag FLUENT into the project schematic Change the name to Catalytic Double click on Setup Choose 3D and Double Precision under Options and retain the other default settings Import Mesh Under the File menu select Import Mesh Select the file catalytic_converter_125k.msh.gz and click OK to import the mesh After reading the mesh, check the grid using MeshCheck option or by using Check under Problem SetupGeneral This starts a new Fluent session and the first step is to import the mesh that has already been created: Setting up the Models Select Pressure Based, Steady state solver Problem SetupGeneralSolver Specify Turbulence model Problem Setup Models Viscous Double click and select k-epsilon (2 eqn) under Model and Realizable under k-epsilon model and retain the default settings for the other parameters Make sure that the Energy Equation is disabled Problem Setup Models Energy Materials Define the materials. Problem Setup Materials Click on air to open Create/Edit Materials panel Click on FLUENT Database… Select nitrogen(n2) from the list Copy Click on Change/Create Flui