Cabling Designer与3D软件CATIA的应用.pdfVIP

Cabling Designer Interface Module CAA V5 Based by : ZUKEN /cn/products/partner-products/all-products/?3dsplmproducts[caav5]=2180cHash=26df6f20f395c7f4e48f52cdabbc c7d3 Keywords : Electrical Design Automation Prerequisites : Any CATIA package including ELB + EWR. Recommended EHI Available since : 7/01/2002 Product Overview Cabling Designer software is a logical harness circuit design system that simplifies the transfer of information between the physical and logical world. It accomplishes this using electro-physical objects. Some examples are Wire, Unit Connector, Wire-Harness-Connector, Joint, Splice, Joint-Connector, Shield, Twist, Bundling, Grouping. Using these electro-physical objects in an environment allows easy implementation of: 1. Wire Harness Variant Design, 2. Hierarchical capabilities allowing entire-system-connections for the wire connections and into the actual units that the wires are connected to, and 3. Fully Customizable Design Rule Check (DRC) capabilities All this combined makes Cabling Designer unique in giving you the capability to deliver a producible design that is cost effective in a minimum amount of time. Cabling Designer Interface Module CAA V5 Based is prepared as Phase-1 of Cabling Designer Integration with CATIA V5. It gives you the full Cabling Designer environment 1. Linking all connections and objects between Cabling Designer and CATIA V5 EWR. 2. Allowing Forward and Backward annotation between Cabling Designer and CATIA V5 EWR via an XML neutral file. 3. Providing integration of CATIA V5 to other CR-5000 utilities around Cabling Designer, such as Topology Designer, Harness Designer, Simulation Verification Module, Variant Module. If you are interested in Phase-2 which will provide more direct integration with CATIA V5, please refer to the term of Cabling Designer CAA V5 Based.