CST MWS例题5【同轴转换接头】.ppt

例五：同轴转换接头计算 The Coaxial Bend with a Tuning stub Start CST MICROWAVE STUDIO? Set Unit and Background Materials Model the Structure (1) Model the Structure (2) Model the Structure (3) Model the Structure (4) Model the Structure (5) Model the Structure (6) Model the Structure (7) Model the Structure (8) Model the Structure (9) create the first part of the conductor (1) create the first part of the conductor (2) Change WCS Create the Second Conductor (1) Create the Second Conductor (2) Add the Conductors (1) Add the Conductors (2) Final Result with different visualization options: Setting Frequency Setting Boundary Condition Setting Symmetry Plane Define Ports (1) Define Ports (2) Define Ports (3) Define Ports (4) Visualize the Mesh Start the Simulation Normalized by Fixed Impedance The Accuracy Solvers Progress 1. Checking model: During this step, your input model will be checked for errors such as invalid overlapping materials, etc. 2. Calculating matrix and dual matrix: During these steps the system of equations, which will subsequently be solved, will be set up. 3. Calculating the port modes: In this step the solver calculates the port mode field distributions and propagation characteristics as well as the port impedances’. This information will be used later in the time domain analysis of the structure. 4. Processing excitation: During this stage an input signal will be fed into the stimulation port. The solver then calculates the resulting field distribution inside the structure as well as the mode amplitudes at all other ports. From this information the frequency dependent S-parameters are calculated in a second step using a Fourier Transformation. 5. Transient analysis: After the excitation pulse has vanished, there is still electromagnetic field energy inside the structure. The solver then continues to calculate the field distribution and the S-parameters until the energy inside the structure has decayed to under a certain limit (specified by the Accuracy setti