无损探伤通用技术规范.docVIP

东方电机股份有限公司 DONGFANG ELECTRICAL MACHINERY CO., LTD. Rev: 0 东方电机股份有限公司 DONGFANG ELECTRICAL MACHINERY CO., LTD 无损探伤 通用技术规范 NDT GENERAL TECHNOLOGY PROCEDURE 东方电机股份有限公司 DONGFANG ELECTRICAL MACHINERY CO., LTD. Rev: 0 编 制 Issued by 刘文高、王麟 校 核 Checked by 邓伟勇 审 定 Approved by 吴天茂 2003年9月18日 无损探伤通用技术规范 NDT GENERAL TECHNOLOGY PROCEDURE Rev: 0 目 录 INDEX 1 锻件超声波探伤规范…………………………………………………… 1 Ultrasonic Inspection Procedure for Forging …………………………… 1 2 焊缝超声波探伤规范…………………………………………………… 5 Ultrasonic Inspection Procedure for Welds …………………………… 5 3 磁粉探伤规范…………………………………………………………… 15 Magnetic Particle Inspection Procedure………………………………… 15 4 液体渗透探伤规范……………………………………………………… 26 Liquid Penetrant Inspection Procedure ………………………………… 26 5 射线探伤规范…………………………………………………………… 34 Radiographic Inspection Procedure …………………………………… 34 锻件超声波探伤规范 Ultrasonic Inspection Procedure for Forging PAGE: PAGE 4 of 48 锻件超声波探伤规范 Ultrasonic Inspection Procedure for Forging 1.1 适用范围 SCOPE 本规范适用于JB4730-94《压力容器无损检测》标准第二篇或ASTM A388规定的钢锻件超声波探伤。 This procedure covers ultrasonic inspection for the iron forged products in accordance with the JB4730-94《Nondestructive testing of Pressure Vessels》Section Ⅱ or ASTM A388. 1.2 设备和人员 APPARATUS AND PRESONNEL 1.2.1 设备 APPARATUS 超声波探伤仪采用A388 4.1条规定的A型超声波探伤仪。探头晶片直径Φ14~Φ29mm，最大有效面积为635mm2，探头频率采用2~5MHz，必要时也可采用1或1.25MHz。 An ultrasonic pulsed reflection type A of instrument shall be required in accordance with part 4.1 of ASTM A388. The probe shall have a maximum active area of 635mm2 with the diameter of 14~29mm max and the probe frequency shall be 2 to 5MHz. If necessary, a frequency of 1MHz or 1.25MHz may be employed, and the areas to be inspected shall be defined on the test report. 1.2.2 Ultrasonic examination equipment shall be calibrated in accordance with ASTM E317 for screen height, horizontal and amplitude linearity. The calibrations shall be at a frequency not to exceed one year. 1.2.3 人员 PERSONNEL 所有从事超声波探伤的人员都应按照GB9445-88《无损检测人员资格鉴定通则》或SNT-TC-1A推荐的方法进行培训和资格鉴定。 All personal perfor