抛丸清理用金属磨料的选择.PDF

现代涂装现代涂装 MPFMPF ModernModern FinishingFinishing 抛丸清理用金属磨料的选择 高 慧，黄振华，王新涛，蒋卓康 （三一汽车起重机械有限公司工艺装备研究院，长沙400100） 摘 要：钢结构件防腐涂装前的抛丸清理 ，有利于清除钢材表面锈蚀 、氧化皮 ，并有效提 高漆膜的附着力。本文研究了金 属磨料的种类及配比对抛丸质量的影响 ，并对金属磨料 的理化性能 ，如硬度 、密度、微观组织、欧文寿命 以及抛丸后钢板粗 糙度对漆膜结合力与耐蚀性做 了系统研究。结果表明，在保证一定除锈等级和漆膜耐蚀性的前提 下，本文首次引进 的 S280+CW0.8 复合配比的丸料 ，在相同的抛丸试验条件下处理后 ，获得 的钢板 除锈质量、表面粗糙度最小及丸料疲劳寿命 综合性能最优。 关键词：抛丸清理 ；磨料 ；粗糙度 ；欧文寿命 中图分类号：TQ639 文献标识码：B 文章编号：1007-9548 （2012）12-0050-04 Selection of Metal Abrasive for Shot Blast Cleaning GAO Hui, HUANG Zhen-hua, WANG Xin-tao, JIANG Zhuo-kang (SANY Mobile Crane Machinery Co., Ltd., Technology and Equipment Research Institute, Changsha 400100, China) Abstract : The pre-blast cleaning before steel structure anticorrosion coating process has advance on remove the rust on the steel surface, oxide skin, and the adhesion of the film was improved effectively. The influence of type and ratios of metal abrasive blasting on quality, and the metal abrasive physicochemical properties, such as hardness, density, microstructure and Erwin life and plate roughness after shot on the bonding strength and corrosion resistance were studied in detail. The results show that, in the guarantee of derusting grade and film corrosion resistance, we first introduced the S280+CW0.8 compound ratio pill material, the optimal comprehensive performance of the steel rust quality, surface roughness and the minimum material fatigue life were got after treated at the same shot experimental conditions. Key words : shot blast cleaning; abrasive; roughness; Ervin life 0 引言 效果以及良好的疲劳寿命。对于同一台抛丸设备，磨料 抛丸处理是利用抛丸设备高速旋