波音飞机密封胶.pptVIP

山东太古飞机工程有限公司培训中心 密封胶常识 波音飞机常用密封胶型号规格及应用 目的与要求 目的： 通过本次课程的学习，达到正确选用密封胶的种类和使用方法的目标。 要求： 了解相关定义，分类，等级和相关替代等。 熟练掌握密封胶的选择，使用方法等。 课程安排 一.基本定义 1. DEFINITIONS （参考 BAC5000） 1.1 Application Time：（施工时间） Amount of time sealant is workable after mixing or thawing; the dash number for Class A, B, D and E sealants specifies application time at Standard Test Conditions; for example, at Standard Test Conditions, BMS5-95 Class B-1/2 has an application time of 1/2 hour and BMS5-45 Class A-2 has an application time of 2 hours. Application Time：密封胶混合好或解冻后直到涂抹到部件上的施工时间。在标准条件下CALSS A,B,D,E后跟的数字指的是Application Time，例如：BMS5-95 Class B-1/2标准条件下Application Time为半小时；BMS5-45 Class A-2标准条件下Application Time为2小时. 一.基本定义 1.2 Squeeze-Out Life（挤出时间） The maximum time allowed after mixing sealant or after thawing frozen sealant until the final fastening of parts with faying surface, injection, and/or prepack seals; the length of time sealant remains suitable for structural assembly of parts with faying surfaces, prepack and/or injection seals; for Class C and G sealants, the dash number specifies the squeeze-out life (for example, squeeze-out life of Class C-48 sealant is 48 hours at Standard Test Conditions). Squeeze-Out Life：密封胶混合好或解冻后直到完成部件紧固件安装的最大允许时 间。在标准条件下CALSS C，G后跟的数字指的是squeeze-out life。例如：Class C-48在标准测试条件下其squeeze-out life为48小时。 一.基本定义 1.3 Tack-Free Time（无粘性时间） The minimum time required for a sealant to cure to a tack-free (non-sticky) condition; 密封胶从施工到无粘性状态的最小时间。 一.基本定义 1.4 Curing Time（固化时间） Time required for the sealant to change from a liquid paste to a rubber at a temperature of 77 ± 5 F , (23 ± 3 C) and 50 ± 5 percent relative humidity. Curing Time：在温度77 ± 5 F, (23 ± 3 C)和 相对湿度50 ± 5%条件下密封胶由糊状变为橡胶状的时间。 二.密封胶的等级 2. LEVELS OF SEALING (参考BAC5000) There are four levels of sealing：absolute, extensive, intermediate and limited. 密封胶有四个等级：绝对密封，完全密封，中等密封和限制密封。 二.密封胶的等级 Absolute：所有开口区域包括紧固件都需密封。（满足