高准质量流量计客户培训质量流量计工作原理和安装投用基本维护.ppt

* The meters are calibrated at the factory on Air and Water. The measurement is very linear so by filling the meter with air and measuring the tube period, and then repeating the process with water a straight-line relationship is determined. Measuring the tube period when the meter is filled with process fluid provides as very accurate on-line density measurement that is available as a monitoring or control variable. * 12/13/96 31 Intro-1 (= Transparency 19) We need to know temperature to compensate for its affect on the elasticity and rigidity of the metal flow tubes, which determine how the tubes responds specifically to flow and density. We’ll discuss that again later. The temperature indicated by the RTD also represents the temperature of the process with considerable accuracy. In current Micro Motion sensor design, the RTD temperature is equivalent to a thermowell sensor in terms of indicating process temperature. * 12/13/96 15 Introduction and Theory, Part II (=Transparency 31) Features of the D series: compatible with all transmitters (except 6-inch sensors, which are not compitible with the IFT9701). Only sensor series that can be used with the RFT9712. standard sensor available in sizes from .06-inch to 6-inch; flow ranges from 0-2 lb/min to 0-25,000 lb/min can be installed up to 1000 feet from transmitter available with high pressure fittings (except DS600) wetted parts 316Lstainless; also available with nickel alloy (with 304 stailess lap joing flanges); or lined with Tefzel (1.5- and 3-inch only) high pressure (DH) and high temperature (DT) models also available in several sizes single-tube, self-draining loop sensor (DL) for sanitary process applications or shear-sensitive fluids is available in .5-, 1-, and 2-inch sizes. Review the function of each of the elements labeled on the transparency. * 12/13/96 23 Introduction and Theory, Part II (= Transparency 39) Correct installation is extremely important. Remember that the sensor will perform accurately