XX有限公司6th燃煤蒸汽锅炉房工艺设计.docVIP

PAGE PAGE I PAGE PAGE 1 XX有限公司6t/h燃煤蒸汽锅炉房工艺设计 摘要 本设计是对一家假想公司6t/h燃煤蒸汽锅炉房的工艺设计，该公司提供一块60000×20000mm的空地来作为锅炉房的地基基础。在文中通过公司给出的数据和对锅炉房设计所需数据的计算，给出了该锅炉房合理的设备选型依据和主要设备的型号，如：锅炉型号、水处理的选择、鼓风机、引风机的选择等。 经计算最终决定采用1台SZL6-1.25-WII型蒸汽锅炉，额定工作压力1.25MPa。由于本锅炉房原水为城市自来水，其硬度和含氧量不符合锅炉给水要求，所以对原水需要进行软化和除氧处理。软化系统选用两台逆流再生钠离子交换器，轮流运行使用。流动床的优点为出水质量高，能连续工作，操作较方便，需要的交换剂量较少。除氧方式为了方便，选用化学除氧中的亚硫酸钠除氧法。对于鼓风机与引风机，根据计算出的烟气量与送风量，分别选取了型号为GG6-15 No.6.9D的鼓风机与型号为GY6-15 No.10.5D的引风机。 在确定了该锅炉房各项设备的型号后，根据GB50041-2008《锅炉房设计规范》和相关技术措施的具体要求，确定了不同规模情况下锅炉房的配置方案，从而确定了锅炉房各个设备的放置位置与汽水管道、烟风管道的平面布置。 关键词：工业锅炉房，锅炉，设计 PAGE PAGE I PAGE PAGE I The design XX CO. LTD.6 t/h coal-fired steam boiler room process Abstract This design is for a hypothetical company 6 t/h coal-fired steam boiler room process design, the company provides a 60000 x 20000 mm of space as a foundation for boiler room. Given in the article through company data and the data required for the calculation of boiler room design, gives a rational of the boiler room equipment selection basis and main equipment models, such as: boiler model, selection of water treatment, air blower, the selection of the induced draft fan, etc. By computing the final decided to adopt 1 SZL6-1.25 - the WII type steam boiler, the rated working pressure of 1.25 MPa. Due to the boiler room raw water for the city tap water, the hardness and oxygen do not conform to the requirements of the boiler feed water, so the raw water to soften and oxygen treatment. Softening system chooses two counter-current regeneration sodium ion exchanger, take turns to run. the advantages of moving bed for water quality is high, can continuous working, convenient operation, less need to exchange dosage. Oxygen way for convenience, choose the sodium sulfite method in chemical oxygen. For fan and induced draft fan, smoke gas and air output, according to the calculated model is respectively chosen for GG6-15 No. 6.9 D blower and models for GY6 - No. 15 10.5 D of induced draft fan.