三维双靶点大斜度定向井井眼轨迹控制技术.PDF

数 码 设 计 ·12 · PEAK DATA SCIENCE 计算机与应用 DOI ：10.19551/ki.issn1672-9129.2019.03.004 三维双靶点大斜度定向井井眼轨迹控制技术三维双靶点大斜度定向井井眼轨迹控制技术 三维双靶点大斜度定向井井眼轨迹控制技术三维双靶点大斜度定向井井眼轨迹控制技术 张凯 (大庆油田有限责任公司采油工程研究院，黑龙江大庆，163453) 摘要：油田进入开发后期，利用多目标定向井技术寻找剩余油，挖潜增效已成为当前的首要任务。通过对 南 4-4-丁斜 30 井的设计与施工，改变了过去多靶点连线方位与井口在同一铅垂面上的二维多目标井的钻 井模式，采用三维多靶点圆弧内切线中靶控制技术，打拐弯变方位多目标井，使设计曲率最小，中靶控制 井段最短。为今后开发断块油藏、边际油藏和不同油层间的剩余油提供了成功的施工经验。 关键词：井位；定向井；三维；井眼轨迹；控制 中图分类号：TE243 文献标识码：A 文章编号：1672-9129(2019)03-0012-04 Borehole Trajectory Control Technology for 3D Double Target Highly Deviated Well Zhang Kai (Oil Production Engineering Institute, Daqing Oil Field Limited-Liability Company, Daqing, Heilongjiang, China, 163453) Abstract: At the later stage of oilfield development, using the technology of multi-target directional well to search for residual oil. Exploiting potential oil and increasing efficiency have become the primary tasks at present.Through the design and construction of well 4-4-T inclined 30 well in south China, the drilling mode of the two-dimensional multi-target well with the connection orientation of the multi-target and the well head on the same plumb surface was changed. The target control technology is adopted in the tangent line of three-dimensional multi-target arc, and the multi-target well with variable azimuth is drilled to minimize the design curvature and the target control well section is the shortest. It provides successful construction experience for developing fault block reservoir, marginal reservoir and remaining oil between different lay