罐体施工落地式扣件钢管脚手架设计.pdf

开 发 应 用 76M罐体施工落地式扣件钢管脚手架设计 王志强 （重庆易成建设工程有限公司，重庆 401520） 摘 要：根据对某结构设计高度为76m的工业混凝土罐体施工组织设计要求，拟采用落地式双排扣件式钢管脚手架，按 照现行相关规范对满足构造要求初选脚手架方案中的纵横向水平杆承载力与扰度要求、扣件的抗滑承载力、立杆稳定性 和立杆地基承载力以及连墙件的强度、稳定性和连接强度分别进行了施工演算，均符合安全要求。 关键词：罐体施工；落地式扣件式钢管脚手架；构造要求；施工演算；安全 DOI：10.3969/j.issn.1671-6396.2010.17.008 Steel Scaffolding Fastener Design on 76 Meters Concrete Tanks Construction m WANG Zhi-qiang o (Chongqing Yicheng Construction Engineering Co,ltd, Chongqing 401520) Abstract:According to construction organization design of 76-meter tall industrial reinforced concrete tank, console double row c fastener tubular steel scaffolding is adopted. According to the relevant rules, under meeting structural requirem ents of primary . scaffold, its pole to plan and flexibility, the sliding resistance capacity, fastener rod stability and pole foundation bearing capacity and even the strength and stability of the wall and the connecting strength are respectively calculated and all safety requirements g are met. n Key words:Tanks construction;Console fastener tubular steel scaffolding;Structural requirements;Constructi on of calculus;Safety lo u 1 概述 h 6 2 2 z0.484×10/0.5386＝95.25N/mm小于205. 该工程初选脚手架形式为双排脚手架，搭设高度为 求。 78.0m。48.0m以下采用双管立杆，48.0m以上采用单管立 .2.3 挠度计算 杆。搭设尺寸为：立杆的纵距1.50m，立杆的横距1.05m， w 最大挠度考虑为简支梁均布荷载作用下的挠度。 立杆的步距1.40m。采用的钢管类型为Φ48×3