IIHS侧面碰撞指南3.pdfVIP

IIHS Side Impact Outrigger Assembly Procedure Base Assembly (14.3 lbs) The base assembly consists of a ¼” thick steel plate, a ¼” thick piece of polyethylene, and mounting fixtures for the upper and lower arms. The plate (P1) measures 10” x 13.5,” with the long edges running parallel to the vehicle. The edge facing away from the vehicle was bent upward slightly. The UHMW polyethylene (P2) is attached to the bottom of the plate with screws recessed into this upturned edge. The two mounting brackets for the lower arms (P20) were