CT机冲击负荷对智能电能表运行状态的影响.docxVIP

第44卷 第504期 电测与仪表 Vol.44 No.504 2007年 第12期 Electrical Measurement Instrumentation Dec.2007 5 - CT机冲击负荷对智能电能表运行状态的影响* 杨芾藜1，侯兴哲1，马姗姗2，王学伟2，刘型志1 （1. 国网重庆市电力公司电力科学研究院，重庆 401123；2. 北京化工大学 信息学院，北京 100029） 摘要：电网中越来越多的大功率设备投入使用，冲击负荷越来越多，冲击负荷不仅对电网的运行状态产生影响，而且，还会导致智能电能表的电能计量超差。本文首先分析医院CT机冲击负荷电流波动的游程特性，然后，建立智能电能表的全系统模型和电能测量仿真算法，最后，仿真分析给出医院CT机冲击负荷对智能电能表运行状态下动态误差的影响，并通过实验验证了仿真分析影响结果。 关键词：智能电能表；动态负荷；运行状态；动态误差 中图分类号：TM933 文献标识码：B 文章编号：1001-1390（2019）00-0000-00 The influence Influence of dynamic impact load characteristics of CT machine on the operating operating state status of smart electricity meter Yang Fuli1, Hou Xingzhe1, Ma Shanshan2, Wang Xuewei2, Liu Xingzhi1 (1. Electric Power Research Institute of .State Grid of Chongqing Electric Power Co.mpany Electric Power Research Institute, Chongqing 401123, China. 2. College of Information Science and Technology, Beijing University of Chemical Technology, Beijing 100029, China) Abstract：: More and more high-power equipment in the power grid is put into use in the power grid, and the impact load is increasing. The impact load not only has an impact on the operating status of the power grid, but also leads to an overshoot of the energy metering of the smart electricity meter. This article paper first firstly analyzes the run-length characteristics of impact current fluctuations in hospital CT machines. Then, a system-wide model of the smart meter and a simulation algorithm for energy measurement is establishedestablish a system-wide model of the smart electricity meter and a simulation algorithm for energy measurement. Finally, the simulation analysis shows the impact of the impact load of the hospital CT machine on the dynamic error of the smart meter. And through experiments itIt is verified that the simulation analysis affects the result through experiments. Keywords：: smart electricity me