温度上下限教材报警程序.docVIP

#include reg51.h #include 18b20.h #define uchar unsigned char #define uint unsigned int uchar code table[]=Min:00 wendu C ; uchar code table1[]=Max:10 00:00:00 ; uchar code table2[]= 00:00:00 ; //以下三个是定义LCD的引脚 sbit lcden=P2^2; sbit lcdwrite=P2^1; sbit lcdrs=P2^0; //定义四个功能开关 sbit s1=P1^4; sbit s2=P1^5; sbit s3=P1^6; sbit s=P1^7; //定义二极管 sbit LED1=P1^0; sbit BEEF=P3^7; uchar time; char hour,min,sec,day,num,wendu,tec=35,flag=0; char shangxian=10,xiaxian=0; //延时程序 void delay(uint z) { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } //lcd的写指令 void write_com(uchar com) { lcdrs=0; lcden=0; P0=com; delay(5); lcden=1; delay(5); lcden=0; } //lcd的写数据 void write_data(uchar da) { lcdrs=1; lcden=0; P0=da; delay(5); lcden=1; delay(5); lcden=0; } //初始化 void init() { uchar num; lcdwrite=0; lcden=0; write_com(0x38); //16*2显示，5*7点阵，8位数据 write_com(0x0c);//显示开，关光标 write_com(0x06); //移动光标 write_com(0x01);//清除LCD的显示内容 for (num=0;num16;num++) { write_data(table[num]); delay(5); } write_com(0x80+0x40); for (num=0;num16;num++) { write_data(table1[num]); delay(5); } /*write_com(0x80+0x40); for (num=0;num16;num++) { write_data(table2[num]); delay(5); } */ TMOD=0x01; TL0=(65536-50000)%256;//定时50ms TH0=(65536-50000)/256; EA=1; ET0=1; TR0=1; } //时间走动 write_hms(uchar add,uchar da) { uchar shi,ge; shi=da/10; ge=da%10; write_com(0x80+0x40+add); write_data(0x30+shi); write_data(0x30+ge); } //温度显示 void write_wendu(uchar add,uchar da) { uchar shi,ge; shi=da/10; ge=da%10; write_com(0x80+add); write_data(0x30+shi); write_data(0x30+ge); write_data(0xdf); } //调节上限温度 void write_wendu1(uchar add, char da) { uchar shi,ge; shi=da/10; ge=da%10; write_com(0x80+0x40+add); write_data(0x30+shi); write_data(0x30+ge); write_data(0xdf); }