XH H 产品分析幻灯片.ppt

Page 重庆双玛科技有限公司 Engineering DFM-REPORT. Chongqing shuangma Technology CO.,LTD Project name: Q3 Issue: DFM – Design For Manufacture - dated the 2016.10.06 产品信息 Product Information mould No（模具编号）: Customer Name（客户名称 ）: Q3 Customer mould No.: 伟巴斯特 Drawing No.: 1732108H 1732103H Cavities: 1+1CAV Material: BERGAMID A70 C20 Part weight: 10 g Part size: 68.8*10*21 Inch/mm: MM * Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 进浇口建议 Gate Advice * 产品采用开放式热嘴转侧胶口进胶，请确认是否OK? 谢谢 Hot bush 1 drop 单热嘴 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 上下模分析 CAV/COR * 产品的前后模定义以及产品的分型线见图上的红色线所示，请确认， 谢谢！ Core side后模 PL 分型线 Cavity side 前模 注:脱模方向 以此凸台的中心面 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 产品分型线 产品的分型线见图片上的红色线所示，请确认， 谢谢！ Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG * 模具结构 产品排位1+1 共有2个滑块 请知悉，谢谢; Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 产品问题点 箭头所示的2处红色R在箭头所示的 红色面R 在后模上有尖钢，影响模具的使用寿命；我们的建议是取消此圈R 请确认是否 OK? 谢谢; Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 产品问题点 箭头所示的 红色面处有插穿位，产品现在没有出模角，我们的建议是减胶0.08mm;增加2度的出模角 ； 请确认是否 OK? 谢谢; Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG * 产品出模分析 Product Draft analysis 箭头所示的产品绿色面没有出模角，请确认是否OK ? 谢谢 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 顶出分析 * 产品的顶出采用 扁顶针与圆顶针， 请确认， 谢谢 3-￠1.5 ￠1.8 ￠4 ￠2 2-￠1.6 2-4*1.2扁顶 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 前模运水布置 前模运水布置，请确认，谢谢 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 后模运水布置 后模运水布置，请确认，谢谢 产品料厚分析 Product Thickness analysis Customer comment. (please give your approval and comments) D