意大利DUPLOMATIC迪普马刀座资料.pdf免费

® DUPLOMATIC AUTOMAZIONE STATIC TOOLHOLDERS ACCORDING TO DIN 69880 for CNC lathes TECHNICAL INFORMATION I.T. 4F01 ISSUED 03-04 ® Main Features DUPLOMATIC AUTOMAZIONE A wide range of static toolholders for CNC turning centers, that foresees all models defined in detail in DIN 69 880 and including a comprehensive line of special holders to meet different requirements. The full range has the following basic technical features : • High quality steel, case hardened with surface hardness of 58-60 HRc. • Disc-side and cutter-side surfaces are ground, for a very high accuracy. • Adjustable any time to the next lower cutter height, with adapters to be ordered separately. • Adjustable cutter position, using two stop screws. • Spring-mounted pressure plates for clamping cutter in the exact position. • Internal coolant supply through ball nozzles, featuring quick and precise adjustment. • Corrosion-resistant to all known coolants and lubricants. • No surface damage due to external factors. • According to DIN 69 880, all toolholders are equipped with a sealing ring on the shaft. 0.1 03-04 ® Index DIN 69 880 Tool holders DUPLOMATIC AUTOMAZIONE Overview Chapter Sheet Blank toolholder 1.1 Form A1 1.2 Form A2 1 Square cross seat 2.1 Form B1 toolholder