外文文献原稿及译文.docVIP

. . 外文文献原稿和译文 原 稿 About Programmable Logiccontrollers（PLCs） PLCs (programmable controller) is used in a variety of automatic control system and process control hub.They contain multiple input and output, input and output is used to transistors and other circuit, analog switch and relay to control the equipment.PLC software interface, standard calculator interface, specialized language programming and network equipment. Programmable logic controller I/O channel rules including all input output contact and contact, to expand capacity and the largest number of channels.Contact number is the sum of input and output points.PLC can specify any combination of these values.Extension units can be stack or connected to each other to increase the total control.The largest number of channels are in an extension system, the total number of maximum input and output channels.PLC system rules include scanning time, number of instructions, data storage and storage program.Scan time is used to monitor input and output module of PLC need time.Standard operation instruction is used in PLC software.Data storage is the ability to store data.Program memory is the ability to control software. Used for programmable controller input devices including DC, AC, intermediate relay, thermocouple, RTD, frequency or pulse, transistors and interrupt signal input;Output devices include DC, AC, intermediate relay, frequency or pulse, transistor, three-terminal two-way thyristor switch components;PLC programming equipment including control panel, handle and computer. Programmable control is used to control a variety of software programming language.These languages including iec61131-3, sequential table (SFC), action block diagram (FBD), ladder diagram (LD), and the structure of the text (ST), instruction sequences (IL), relay ladder diagram (RIL), flow charts, C language and Basic language.Iec61131-3 programming environment can support five languages, with international standards to