asme射线检测程序.docVIP

Zhenjiang JinMen Industrial Co., Ltd ASME Procedures JM/ASME-09 Radiographic Testing Procedure Rev. No.: 0.0 Page： PAGE 1 of 22 Radiographic Testing Procedure 射 线 检 测 程 序 Prepared by Date _____________ 编 制： 日期： Approved by _________________ Date ____________ 批 准： 日期： Accepted by _________________ Date ____________ 认 可： 日期： Zhenjiang JinMen Industrial Co., Ltd ASME Procedures JM/ASME-09 Radiographic Testing Procedure Rev. No.: 0.0 Page：2 of 22 1.0 Scope 范围 1.1 This procedure defines the requirements of radiographic examination of pressure vessels and other components manufactured in according to ASME Boiler and Pressure Vessel Code Section V and Section Ⅰ，B31.1and VIII Div.1, latest applicable edition and addendum. Preparation and modifications to this procedure may only be made by a duly certified NDT level III. 本程序根据ASME规范的第V卷以及第Ⅰ卷，B31.1和第Ⅷ卷第１分册的最新版本和附录规定了压力容器和其它生产零件射线检验的要求 1.2 The product material and its thickness limits refer to applicable NDT instruction. 产品的材料和它的厚度限制参考适用的NDT的指导。 2.0 Equipment and Materials 设备和材料: 2.1 Radiation Sources 放射源: 2.1.1 Type XXH3005Z, XXG3005D and X-Ray units are used in JM. 型号XXH3005Z, XXG3005D 和 X-Ray组使用在JM Manufacturer 生产厂商 Model 型号 Pipe Voltage 管的电压 KV Pipe Current 管的电流 mA Focus measurement 焦点测量( mm) Max. thickness to be radiographic examined 射线检验的最大厚度 (mm) Dandong 丹东 XXH3005Z 170～300 5 1.0×6.0 40 Dandong 丹东 XXG3005D 170～300 5 2.5×2.5 40 2.1.2 Other equipment may be used provided equivalent or better results are obtained. 倘若等同或较好的结果被获得，可能适用其它设备。 2.1.3 The equipment manufacturer or supplier shall supply source size verification, such as technical manuals, decay curves, or written statement documenting the actual or maximum source size or focal spot. 设备生产厂商或供货商应提供，例如技术手册、衰减曲线、或书面声明证明实际的最大透照尺寸或焦点尺寸。 2.2 Films 胶片 Radiographs shall be made using industrial radiographic