哈尔滨600玻瓶图纸.docVIP

1. Heel/Bottom Plate Lettering Requirements: A) “B” to appear in a straight line on one side of the heel as shown round nosed style raised .3 maximum in glass. B) Factory letter, year date, cavity # and trademark to appear on the heel sufficiently separated from the legend statements or on the bottom plate. C) Emhart Dot Code-The code dots may be used on one side of the heel. No glass to glass contact of the lettering or dots will occur when two bottles are placed together and rotated. D) Concentric Rings-Cavity # to appear in the center of the bottom plate. E) AGR Bottom Plate dots-All information as in (A) and (B) above. 2. Crescent knurling or bar knurling to appear on bearing surface. 3. Random shoulder and heel Ice decoration to appear as shown on each half of the bottle. The pattern will be relieved for proper draft such that no decoration to decoration contact occurs between bottles. 4. Out-Of-Perpendicular-Bottles will not deviate from the perpendicular for any reason(s) more than 4.8 when rotated 360° measured at the finish. 5. Drawing is not to scale. All dimensions are expressed in millimeters. Reference Glass Weight: 485.0 grams Standard Overflow: 625.0 +/-6 ml Average Capacity at Fill Point： 600+/- 1.5ml Zone Technical Development—China 600 ml LNNR Ice TR - China Specification: Date: I-C-233-D 7/24/2010 Page 1 of 2 Pages 600HARB1.DWG 附：瓶跟加“百威英博”4个字要求： 文件更新记录 日期 作者 版本说明 自前一版本以来的主要的或重要的变更 2009-11-10 侯春毅 Bud Ice 600和Harbin Ice 600公用一个瓶型，沿用原AB的图纸，但对灌装容量的均值公差要求为+/-1ml, 单瓶要求为+/-6ml，且瓶跟增加了“百威英博”4个字的要求。 2010-7-24 侯春毅 根据百威英博通用标准的更新，将平均灌装容量公差要求由600+/- 1ml改为600+/-1.5ml。 Page 2 of 2 Pages