SOR 711 超声波液位开关.pdf

Model 711 through 722, 24 VDC, 120 VAC or 240 VAC power supply with notch-type, or viscous sensors Ultrasonic Point Level Switch (One and Two Point) General Instructions The Ultrasonic Point Level Switch indicates liquid presence/absence within a sensor cavity. Two piezoelectric crystals face each other across the sensor cavity. One crystal transmits an ultrasonic signal; the other crystal receives the signal. When the sensor cavity is empty, the receiver detects a weak signal because air is a poor conductor of ultrasonic waves. With the failsafe switch in the “HI” position, the normally open relay contacts remain open, and the Liquid Level LED is not lit. When process liquid fills the sensor cavity, the receiver detects a strong signal because liquids are good conductors of ultrasonic waves. With the failsafe switch in the “HI” position, the normally open relay contacts are closed, and the Liquid Level LED is lit. The Failsafe Slide Switch reverses the relay actuation. However, the liquid level LED is lit only when the relay is energized. The sensor monitor circuitry (standard on 721 and 722 series switches only) constantly monitors sensor integrity and opens the normally open contacts of the sensor monitor relay in the unlikely event of a sensor failure. The relay is energized when the sensor is operating properly. ® NOTE: If you suspect that a product is defective, contact the factory or the SOR Representative in your area for a return authorization number (RMA). This product should only be installed by trained and competent personnel.