网络布线的原理和标准2.ppt

13 15 16 18 6 2 3 5 11 16 26 26 27 28 29 3 Emphasize: Make sure each student has seen a Cat 5 cable. Describe the test for straight through cable determination. If you hold the two ends of an RJ-45 cable side by side, youll see eight colored strips, or pins, at each end. If the order of the colored pins is the same at each end, then the cable is straight through. If the order of the colors is reversed at each end, then the cable is crossed over or rolled. Straight-thru Ethernet uses pins 1, 2, 3, and 6. Straight-thru cables are used for switch to router cabling, switch to PC or server cabling, or hub to PC or server cabling. Emphasize: Make sure each student has seen a Cat 5 cable. Describe the test for crossover cable determination. If you hold the two ends of an RJ-45 cable side by side, youll see eight colored strips, or pins, at each end. If the order of the colored pins is the same at each end, then the cable is straight through. If the order of the colors is reversed at each end, then the cable is crossed over or rolled. Ethernet uses pins 1, 2, 3, and 6. For crossover, pin 1 is connected to 3, and oin 2 is connected to 6. Crossover cables are used for switch to switch cabling, PC to PC cabling, switch to hub cabling, hub to hub cabling, or router to router cabling. 双绞线线序只要满足上述线序都能正常传输数据 但应注意制作线缆时应严格按照568A/B的标准，将线缆间的干扰降到最低 某些不和规范的双绞线或者弱电工程中并没有严格按照568A/B的标准，故障排查时一定要注意 8 * 上述线缆通过普通双绞线测试仪发现连通性没有问题，但连接至网络设备后端口无法UP 8 * 通常看到工人敷设的黑色线缆叫做光缆，里面包含了多组光纤 8 * 单模光纤，光向一个方向稳定传输，单位时间传递的信息量更大 8 * 目前网络设备最常用的光纤接口是LC 光纤跳线架或光纤终端盒一般使用SC、LC、ST 8 * 光电转换器100M的居多 8 * * * * 2 10 11 20 22 23 27 33 44 50 30 56 55 35 35 35 3 The installation procedure for the MGS400 differs from the previous MGS300. The new wiring scheme is illustrated above and is also documented in the Product Instruction Sheet printed on the MGS400 packaging. Detailed installation instructions have also been incorporated in the updated SYSTIMAX SCS Cable Design and Installation Guidelines. 11 过压保护 采用气体保护