穴盘苗自动移栽机苗盘回收机构设计与试验.PDFVIP

() 2014 6 40 3 Journal of Hunan Agricultural University (Natural Sciences), Jun. 2014, 40(3):330–333 DOI:10.13331/ki.jhau.2014.03.021 /qks 穴盘苗自动移栽机苗盘回收机构设计与试验 1 1,2* 1,2 1,2 1,2 1,2 (1. 410128 2. 410128) 摘 要 βR n β 55°65° R 120160 mm30120 r/min β 60°R 140 mmn 30 r/min 关 键 词 中图分类号S223.9 文献标志码：A 文章编号：1007− 1032(2014)03−0330−04 Design and test of seedling tray recovery mechanism for transplanting machine of hole tray seedlings 1 1,2* 1,2 1,2 1,2 1,2 QUAN Wei , SUN Song-lin , XIAO Ming-tao , LI Jun-zheng , GAO Xiang-yu , LUO Jiang-he (1.College of Engineering, Hunan Agricultural University, Changsha 410128, China; 2. Hunan Provincial Engineering Technology Research Center for Modern Agricultural Equipment, Changsha 410128, China) Abstract: To realize the full automation of seedling transplanting, the automatic recovery mechanism of seedling tray was designed based on the homemade seedling transplanting machine. The mechanism is mainly composed of a conveyer belt, lifting cam, a limit block and a set of plate frame. The seedling tray fell to the conveyer belt in a certain angle after the seedling was recovered, then transported to the plate frame by the conveyer belt, and finally lifted to the limit block that is in the plate frame to complete the automatic recovery which was mainly influenced by the falling angle of seedling tray β, the radius of lift cam R and the speed of revolution n. Through single factor test seedling plate falling angle β of 55°–65°, cam profile radius of lifting R of 120–160 mm, and the cam speed n of 30–120 r/min were obtained. Through multi factor orthogonal test the best combination with seedling