美国材料协会标准 A1090 - A 1090M - 19.pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A1090/A1090M − 19 Standard Specification for Forged Rings and Hollows for Use as Base Plates in Power Transmission Structures1 This standard is issued under the fixed designation A1090/A1090M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. 1. Scope* ensure conformance with the standard, each system shall be 1.1 This specification covers high-strength, low-alloy steel used independently of the other, and values from the two ring and hollow forgings intended primarily for use as base systems shall not be combined. plates in welded tubular structures for power transmission 1.7 This standard does not purport to address all of the applications. However, use of this specification is not restricted safety concerns, if any, associated with its use. It is the to such applications and it may be used in other applications for responsibility of the user of this standard to establish appro- which the attributes of the materials, as defined by this priate safety, health, and e