spotrepairnewpresentation宝马喷漆工艺.pptVIP

2 Polished area 1 ?  ? ?  1. Basecoat 2. Clearcoat 3. Spot Blender The clear is applied in 1 to 3 spraycoats, starting from the centre of the repair, covering the basecoat application area (1) and reaching slightly beyond the area fine-sanded with P2000 (2). It must be made sure that the sanding marks left by the P2000 abrasive are completely covered with clearcoat. ? Then Glasurit? 352-500 Spot Blender is applied to the transition from repair clearcoat to polished old paintwork (3), fading out into the polished area. ? 3. Summary of the Spot-Repair process steps IX. Drying of Glasurit? Clears Short-wave infrared drying, for example with: IRT EXLNC with pyrometer: 10 min at 20°C - 100°C XLNC without pyrometer: 10 min at power level 4 Infrared drying in general 10 min at 100% Thorough drying before polishing is essential. X. Polishing after cooling For example with: 3M Perfect-It III System 3M Fast Cut Compound on repair and fade-out zone Commercial polishing machines, e.g. Rupes, Mirka, Festo. Polishing to be done at level 6-7, applying only slight pressure. XI. Inspection of polished panels Spray on Glasurit? 700-1 Cleaner and wipe dry. Check if surface looks mat. If necessary dry and polish again. Remove masking film or paper. Clean the vehicle. Carry out quality control. XII. Delivery of the vehicle Before delivering the vehicle to the customer: Place brochures and flyers in the vehicle. Inform the customer about additional services available. Recommended consumables and tools Alternative products Supplier Product Pack/Unit Order code SIA Siacar 1941, diam. 80 mm SIA P180 50 T 8998.0180.6 SIA P280 50 T 8998.0280.6 SIA P400 50 T 8998.0400.6 SIA P800 50 T 8998.0800.6 SIA Siamic 1990, diam. 80 mm P1200 50 T 8999.1200.6 SIA Sia fleece with cloth, diam. 80 mm, grey 10 T 8995.0600.3 SIA Orbital sander, 2.5 mm 1 T 8923.0000.1 SIA Round sanding block with Microbur, diam. 7