思科catalyst 2960 3750-e 3560-e 产品预览教材.pptVIP

* The sequence shown above is the following: 1. Switch and phone exchange CDP; trust boundary is extended to IP Phone. 2. Phone sets CoS to 5 for VoIP and to 3 for call signaling traffic. 3. Phone rewrites CoS from PC to 0. 4. Switch trusts CoS from phone and maps CoS to DSCP for output queuing. CDP is a lightweight, proprietary protocol engineered to perform neighbor discovery; it was never intended as a security or authentication protocol. Therefore, to improve the security of conditional trust extension, the next generation of Cisco IP Telephony products will incorporate the use of advanced protocols to perform authentication. * * * * * Add text * Mention software release for the platform(s) here * * * Flexlinks provides L2 redundancy without requiring spanning tree. Primary and backup interfaces are configured to forward traffic. Prior to 12.2(37)SE release, only one of the links could forward traffic. In this release, VLAN based load balancing is supported, increasing network throughput. * We support TDR in 2960 and 3750/3560 IP BASE/IP SEVICES 6K: /news/cisco/eng/sevt-rtsw-all/msg01957.html The TDR feature is HW based and only presently available in the new 10/100/1000 line cards. It is not available in any of the 10/100 line cards. Support is included in the new WS-X6148-GE-TX WS-X6548-GE-TX. TDR can be used to check cable pairs for errors such as degraded speed or higher packet loss, which can cause poor performance of the cable. It can also detect whether the cable is open, short, or broken. The length of the cable or the location of a problem can also be detected. The TDR detects a cable fault by sending a signal through the cable and reading the signal that is reflected back to it. All or part of the signal can be reflected back by any number of cable defects or by the end of the cable itself. * We support UDLD and aggressive UDLS in every DSBU switch as well Less useful on Ethernet Links as physical transmit receive in common connector Each sw