UL94标准(中英文对照).docVIP

UL94标准 ? ? ?UL94 HB flammability standard (UL94 HB可燃性标准) o ? ?Requirements for HB (HB的要求条件) ? ? ?UL94 V-0, V-1, V-2 flammability standard (UL94 V-0, V-1, V-2可燃性标准) o ? ?Requirements for V-0 (V-0的要求条件) o ? ?Requirements for V-1 (V-1的要求条件) o ? ?Requirements for V-2 (V-2的要求条件) ? ? ?UL94 5VA 5VB flammability standard (UL94 5VA 5VB可燃性标准) o ? ?Requirements for 5VA (5VA的要求条件) o ? ?Requirements for 5VB (5VB的要求条件) ? ? ?UL94 criteria summary (UL94判定标准摘要) ? ? ?Glow Wire testing ? ? ?Obtaining material recognition (取得材料认证) ? ? ?UL test descriptions (UL测试描述) ? ? ?UL file numbers for RTP Company (RTP公司的UL档案号码) ? ? ?Requesting a UL Yellow Card from RTP Company (向RTP公司要UL黄卡) UL 94 HB flammability standard(UL94 HB可燃性标准)Specimen 试片 Length 125 mm (5 in) x Width 13 mm (0.5 in) x Thickness [typically 1.5 mm (1/16 in) or 3.0 mm (1/8 in) or 6.0 mm (1/4 in)]. 长125mm(5)X宽13mm(1/2)X厚度[一般为1.5mm(1/16)、3.0mm (1/8)或6.0mm (1/4)厚]Procedure 程序 1. ? ?Three specimens of each thickness are tested after conditioning for 48 hours at 23 degrees C and 50% RH.每一种厚度准备了三个试片，测试前先在23℃和50%相对湿度下放置48小时。 2. ? ?Each specimen is mounted with its long axis horizontal and its short axis at a 45 degree angle.每一试片以长轴呈水平、短轴呈45°方式固定。 3. ? ?Each specimen is marked with two lines, 25 mm and 100 mm from one end of the specimen. 每一试片在25mm及100mm处画线做记号。 4. ? ?Each specimen is supported at one end such that its lower edge is 10 mm above a piece of wire gauze. 每一试片之一端固定，低缘下方10mm处水平放置一片金属细网。 5. ? ?A 20 mm high blue Bunsen burner flame is applied to the free end of the specimen for 30 second and then removed. If the specimen continues to burn after the removal of the test flame, the time for the flame front to travel between the two gauge marks is measured and the burning rate calculated in millimeters per minute. 一个20mm高蓝色本生灯火焰燃烧试片未固定之一端30秒钟然后移开。 在火焰移开后假如试片继续燃烧，则测出火焰由前缘燃烧至2个记号之间所用的时间。 燃烧速率以mm/min计算。Requirements for HB HB等级的判定标准6. ? ?The specimens may not have a burn rate exceeding 40 mm per minut