STM32温度报 警传感器代码.docVIP

主函数 、main.c #include led.h #include delay.h #include sys.h #include usart.h #include lcd.h #include ds18b20.h #include key.h #include string.h #include stdio.h #include stdlib.h int temp_low = 22; int temp_high = 32; int zanshi_low=0; int zanshi_hign=0; void TIM3_Int_Init(u16 arr,u16 psc) { TIM_TimeBaseInitTypeDef TIM_TimeBaseStructure; NVIC_InitTypeDef NVIC_InitStructure; RCC_APB1PeriphClockCmd(RCC_APB1Periph_TIM3, ENABLE); //时钟使能 TIM_TimeBaseStructure.TIM_Period = arr; //设置在下一个更新事件装入活动的自动重装载寄存器周期的值 计数到5000为500ms TIM_TimeBaseStructure.TIM_Prescaler =psc; //设置用来作为TIMx时钟频率除数的预分频值 10Khz的计数频率 TIM_TimeBaseStructure.TIM_ClockDivision = 0; //设置时钟分割:TDTS = Tck_tim TIM_TimeBaseStructure.TIM_CounterMode = TIM_CounterMode_Up; //TIM向上计数模式 TIM_TimeBaseInit(TIM3, TIM_TimeBaseStructure); //根据TIM_TimeBaseInitStruct中指定的参数初始化TIMx的时间基数单位 TIM_ITConfig( //使能或者失能指定的TIM中断 TIM3, //TIM2 TIM_IT_Update , ENABLE //使能 ); NVIC_InitStructure.NVIC_IRQChannel = TIM3_IRQn; //TIM3中断 NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0; //先占优先级0级 NVIC_InitStructure.NVIC_IRQChannelSubPriority = 3; //从优先级3级 NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE; //IRQ通道被使能 NVIC_Init(NVIC_InitStructure); //根据NVIC_InitStruct中指定的参数初始化外设NVIC寄存器 TIM_Cmd(TIM3, ENABLE); //使能TIMx外设 } u8 flag=0; int main(void) { u8 t = 0; u8 shuzu[20]; u8 keyvalue=0; u8 gaibianshui=0; short temperature; delay_init(); //延时函数初始化 uart_init(9600); //串口初始化为9600 NVIC_PriorityGroupConfig(NVIC_PriorityGroup_2);// 设置中断优先级分组2 LED_Init(); //初始化与LED连接的硬件接口 TIM3_Int_Init(9999,7199);//10Khz的计数频率，计数到5000为500ms LCD_Init(); POINT_COLOR = RED; //设置字体为红色 LCD_ShowString(0, 50, 200, 16, 16, STM32 test); LCD_ShowString(0, 70, 200, 16, 16, name: zhang qi qi ); //LCD_ShowString(0,90,200,16,16,Max 32 C Min 26 C); memset(shuzu, 0, 20); sprintf(shuzu, Max is %2d C,Min is %2d C, temp_high, tem