基于MATLAB的电力电子电路仿真分析）.docVIP

河南科技学院机电学院本科学位论文 PAGE IV PAGE I 2010 届本科毕业论文 论文题目：基于MATLAB的电力电子电路仿真分析 学生姓名： 所在院系： 机 电 学 院 所学专业： 电气工程及其自动化 导师姓名： 沈 宏 完成时间： 2010 河南科技学院机电学院本科学位论文 摘 要 电力电子技术课程是电气信息类学生所必修的一门专业基础课程，其理论性和实践性很强。本文以MATLAB软件的SIMULINK仿真软件包为平台，对几种常见的电力电子电路进行仿真分析，内容涉及单相桥式全控整流电路、单相桥式有源逆变电路、三相半波可控整流电路、BUCK直流/直流变换电路进、桥式直流PWM变换电路。文章对每个电路首先进行原理分析，进而建立相应的仿真模型，经过详细计算确定并设置仿真参数进行仿真，对于每次仿真结果均采用可视化波形图的方式直接输出。在对仿真结果分析的基础上，不断优化仿真参数，使其最大化再现实际物理过程，并根据各个电路的性能进行参数改变从而观察结果的异同。通过仿真软件MATLAB /SIMULINK建立的电路动态仿真模型，验证了模型的正确性、灵活性和直观性，并克服了以往分析过程中系统接线复杂和改变接线困难等缺点。MATLAB / SIMULINK 为电力电子系统引入了一个有效的学习和分析工具，是学生深刻理解掌握该课程和老师生动形象教授该课程的有力工具。 关键词：电力电子电路，MATLAB，计算机仿真 Abstract The course of power electronics is the required specialized course for the students majoring in electrical information. The course has high theory and practice. Based on the software package of SIMULINK in MATLAB, this paper simulates and analyzes some basic power electronics circuits, including Single-Phase Full-Bridge Controlled Rectifier, Single-Phase Full-Bridge Active Reverser, Three-phase Whole-wave Circuit of Silicon Controlled Rectifier, Buck Converter and PWM Generator. First, the principle of each circuit is researched, then the respect model simulation is established, and the simulation parameters are gained through accurate calculation. At last, the result of each simulation is directly output in the form of visual waveform. The simulation results are all fully studied and the simulation parameters are optimized again and again accordingly, consequently, the actual physical process is highly approximated. The parameters are also changed regularly so as to validate the theory. Through simulation software MATLAB / SIMULINK, this article establishes the dynamic simulation model of power electronics circuit, confirms the correctness, vivacity and agility of the model. And the defects of complex wiring and difficult in changing have been avoided. MATLAB / SIMULINK has introduced a valid tool to power electronic system, it proved to