稠油掺稀液压反馈式抽稠泵杆柱设计优化_图文.docVIP

西南石油大学学报(自然科学版 2013年10月第35卷第5期 Journal of Southwest Petroleum University(ScienceTechnology Edition V ol.35No.5Oct.2013 DOI:10.3863/j.issn.1674–5086.2013.05.023 文章编号:1674–5086(201305–0157–08 中图分类号:TE933 文献标识码:A 稠油掺稀液压反馈式抽稠泵杆柱设计优化* 袁波,杜林辉,梁志艳,唐健,姜建华 中国石化西北油田分公司塔河采油二厂,新疆轮台841604 摘要:塔河油田为碳酸盐岩超深、超稠油油藏,因油稠配合掺稀生产,有杆泵举升主要以针对稠油掺稀设计的液压反馈式抽稠泵为主。对液压反馈式抽稠泵在掺稀井中的受力情况进行分析,并对各种载荷的构成因素进行敏感性评价,得出动液面及混合液黏度是影响载荷的最敏感因素。在受力分析的基础上,找出了目前杆柱设计方法存在的问题,并对杆柱断脱原因进行了分析。通过大量实测及计算数据对比,得出优化后杆柱受力计算误差更小、受力状况评价更加准确的结论,应用优化后的计算方法,计算出目前各种机杆泵组合情况下的最大抽深,用于指导生产管理。 关键词:稠油;掺稀;液压反馈式抽稠泵;受力分析;杆柱设计优化 Rod Design Optimization of the Hydraulic Feedback Pump of Heavy Oil Mixed with Light Oil Yuan bo,Du Linhui,Liang Zhiyan,Tang Jian,Jiang Jianhua No.2Oil Production Plant,Tahe Oilfield,Northwest Branch Corporation,SINOPEC,Luntai,Xinjiang841604,China Abstract:Tahe Oilfield is a carbonate reservoir with ultra-deep,ultra-heavy oil,which needs to mix with light oil.Sucker rod pumps are mainly the hydraulic feedback heavy oil pump,which is designed specifically for heavy oil production.The stress situation of hydraulic feedback heavy oil pump in mixing light oil wells was analyzed,and the sensitivity of various loading factors was evaluated,and finally we put forward that producing fluid level and viscosity of the miscible liquids are the most sensitive factors affecting the loading.On the basis of force analysis,we identify the problems of rod string designing method at present and analyze the reasons of the rupture and out of joint of the sucker sod.Through a lot of comparison of the measured and calculated data,we draw the conclusion that the stress error of optimized poles is smaller and the stress status evaluation is more accurate.The optimized calculation method will be used to calculate the maximum pump depth for various combinations of the oil extractor,rod and pump,and to guide the production management. Key words:heavy oil;blending light oil;hydraulic feedback heavy oil pump;stress analysis;rod design optimizatio