AASHTO 线性振幅扫描评价沥青混合料的抗疲劳性能.pdfVIP

Standard Method of Test for Estimating Fatigue Resistance of Asphalt Binders Using the Linear Amplitude Sweep AASHTO Designation: T XXX-10 1. SCOPE 1.1. This test method covers the indication of asphalt binders’ resistance to fatigue damage by means of cyclic loading employing a linearly ramping amplitude sweep test. The amplitude sweep is conducted using the Dynamic Shear Rheometer at the continuous intermediate temperature performance grade (PG Grade) of the asphalt binder. The test method can be used with material aged using AASHTO T 240 (RTFOT) and/or AASHTO R 28 (PAV) to simulate the estimated aging for in-service asphalt pavements. 1.2. The values stated in SI units are to be regarded as the standard. 1.3. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 2. REFERENCED DOCUMENTS 2.1. AASHTO Standards : M 320, Standard Specification for Performance Graded Asphalt Binder T 240, Effect of Heat and Air on Rolling Film of Asphalt (Rolling Thin-Film Oven Test) R 28, Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel (PAV) T 315, Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR) 2.2. ASTM Standards : D 8, Standard Terminology Relating to Materials for Roads and Pavements D 2872, Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin- Film Oven Test) D 6521, Standard Practice for Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel (PAV) D 7175, Standard Test Method for Determining the Rheological Pr