UP3000-100海上型风机超速模块参数设置说明.pdfVIP

GA-30.1-EC.OS.00.01-A-A Important Notice and Disclaimer This document may still be undergoing checking by the institution responsible, unless approval has been given with appropriate notification appearing on the document. Although all work has been carried out very thoroughly, this document is still subject to changes. The risk of manufacturing in accordance to this document or any other use of the results stays exclusively with the customer and is not in the responsibility of GDUPC. Should any information in this document be not complete, incomprehensible or faulty, it is the responsibility of the user of this document to immediately clarify the facts with the author and the client. Upon the use of this document the user agrees that GDUPC can only be held responsible for intent and gross negligence and that liability for consequential damage is impossible. This document is only submitted under the assumption that the receiver accepts the above conditions. Revision Summary Revision Date Description of modification A 2012-05-30 First Version UP3000-100 海上型风力发电机组超速模块 （IFM ）参数设置说明 Page 1/4 GA-30.1-EC.OS.00.01-A-A UP3000-100 双馈式海上型风力发电机组 超速模块（IFM ）参数设置说明 一、说明 本说明文档适用于3MW50HZIIA 海上型机组所用超速模块的参数设置。其 他机型配置文件下载方法可参考本文档，但各参数需要重新计算。 二、超速模块探头安装位置 超速模块探头（接近开关）安装在主轴与齿箱连接护套的位置，检测护套上 的安装螺帽（共32 个）。如下图1 所示，绿色箭头表示接近开关及安装方向，红 色折线表示传感器安装支架。 被测螺帽 安装支架 接近开关 图1 超速模块探头安装位置与被测螺