激光打印机打印歪斜度的校正方法研究.pdf

第40 卷 第9 期 包 装 工 程 2019 年5 月 PACKAGING ENGINEERING ·167 · 1 1 1 2 （1.成都工业学院，成都 611730 ；2.哈尔滨工业大学，哈尔滨 150001 ） 目的 针对激光打印机常见的打印图像歪斜问题，以激光打印原理为理论基础，研究并设计打印 歪斜的校正方法。方法 首先，利用激光打印机自身的硒鼓结构制作测试组件，详细介绍其制作方法及 工作原理；然后，设计专门的测试样张；最后，将测试组件放入打印机，并打印该测试样张。结果 按 照文中所述的方法可精确检测并调整激光束位置，从而达到校正打印歪斜度的目的。结论 该方法可快 速、精确地检测激光束的位置和歪斜状态，可将打印歪斜度精准校正至允许范围内，尤其适用于产品试 制阶段的样机调试以及产品售后维保阶段。 激光打印机；打印歪斜；激光束；校正方法；测试样张 TS801 A 1001-3563(2019)09-0167-07 DOI 10.19554/j.cnki.1001-3563.2019.09.027 Correction Method for the Printing Skew of Laser Printer 1 1 1 2 LIU Ping-ping , XU Hong , LI Gang-jun , SUO Lai-chun (1.Chengdu Technological University, Chengdu 611730, China; 2.Harbin Institute of Technology, Harbin 150001, China) ABSTRACT: In view of the common skew of the printing image of a laser printer, the work aims to study and design the correction method of the printing skew based on the principle of laser printing. First of all, the laser printers cartridge structure was used to make the test module, and the manufacturing method and working principle were introduced in detail. Secondly, a special test sample was designed. Finally, the test component was put into the printer and the test sample was printed. The laser beam position could be accurately tested and adjusted according to the proposed method so as to correct the skew of printing. This method can quickly and accurately test the position and skew state of the laser beam, and accurately correct the printing skew to the allowable range. This method is especially suitable for