业务支撑网网络技术之广域网概论.pptVIP

* * * * * * Slide 1 of 6: Purpose: This figure shows how the show interface command is used to verify whether Frame Relay operation and router connectivity to remote routers are working. Emphasize: Describe the highlighted output to the students. * * Slide 2 of 6: Purpose: This figure shows how the show frame-relay LMI command is used to verify the LMI type used for signaling. Emphasize: Describe the highlighted output to the students. * * Slide 3 of 6: Purpose: This figure shows how the show frame-relay pvc command is used to verify whether Frame Relay operation and router connectivity to remote routers are working. Emphasize: Describe the highlighted output to the students. * * Slide 4 of 6: Purpose: This figure shows how the show frame-relay map command is used to verify that Frame Relay has a map entry in the Frame Relay map table. Emphasize: Describe the highlighted output to the students. * * Slide 5 of 6: Purpose: This figure shows how the clear frame-relay-inarp command is used to clear dynamically created Frame Relay maps. * * * * * * * * * * * * PPPoE配置实例二(Cisco2600接ADSL Modem) vpdn enable 　　no vpdn logging 　　! 　　vpdn-group 1 　　request-dialin 　　protocol pppoe 　　! 　　interface Ethernet0/0 　　ip address 2 　　ip nat inside 　　no ip mroute-cache 　　interface Ethernet0/1 　　no ip address 　　pppoe enable 　　pppoe-client dial-pool-number 1 　　! 　　interface Dialer1 　　ip address negotiated 　　ip nat outside 　　ip mtu 1492 　　encapsulation ppp 　　no ip mroute-cache 　　dialer pool 1 　　dialer-group 1 　　ppp authentication pap 　　ppp pap sent-username cisco password cisco1 　　! 　　ip classless 　　no ip http server 　　! 　　dialer-list 1 protocol ip permit 　　ip nat inside source list 1 interface Dialer1 overload 　　ip route dialer1 　　access-list 1 permit 55 The End * * * * * * * * * * * * * * * * * * * * * * * * * * Purpose: This figure describes how to encapsulate PPP on an interface. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Layer 3 of 3: Purpose: