LTE ECM 拨号.pdfVIP

 ConnectLTEmoduletothehostviaUSB,poweronthemodule, waittofinishboot  Openashellwindowonhost  Input shell command: ifconfig, should find a new Ethernet device,e.g eth0/usb0  Inputshell command: ls/dev/ttyUSB*, should lista new USB serialportdevice,e.g /dev/ttyUSB0  Useaserialporttoollikeminicomtoopen/dev/ttyUSB0 Now, use AT commands to control the module refer to the document“HUAWEIModuleATCommandInterfaceSpecification” Howto usedataservice InputtheseATcommandsinminicom  AT+COPS?//checkifhasanynetwork  AT^NDISDUP=1,1,”APN”//dial-up,“APN”shouldbechangedto therealsetting Ifsuccess,URCwillbereceived:^NDISSTAT:1,,,IPV4“ Inputshellcommands  dhclienteth0,obtainIPandDNSaddressofeth0device  ifconfig,checktheIPaddress Now,pleaseusetheInternet InputthisATcommandinminicom  AT^NDISDUP=1,0//disconnectnetwork 发送AT指令格式： cat/dev/ttyUSB2 echo –e “ati\r\n”/dev/ttyUSB2 Linux启用模块虚拟网口的命令： ifconfigech0up 启用模块网口 udhcpc-iech0 网口配置拨号后获取的IP地址 可以修改成USB0 安卓系统启用模块虚拟网口的命令： killall-9udhcpc udhcpc-b-i$interface 这个是客户使用的命令，请悉知。