双色液位计说明书.pdfVIP

    双色液位计说明书   MANUALOFDOUBLEOILLEVELGAUGE              南通九洲船舶机械制造有限公司  NanTongJiuZhouShipMechanicalFittingsCo.,Ltd. 地址：南通市城港路858号 Address:858#,ChenGangRoad,NanTongCity, 电话TEL：0513传真FAX：0513   1. 开箱，安装箱单明细检验零件数量。 Outofthebox,packinglistnumberdetailinspectionofparts 2.按中心长度H（见附表），在油柜（件4）上开大于Φ42的孔两个。（长度H的偏差值不得大于2mm）， 将油位计上下焊接座（件18）插入其中，焊牢。 Press Center-length h (see schedule), at the oil tank (4) drive is greater than 42 diameter hole in two. (Deviation shall not be greater than the value of the length h 2mm), the oil level gauge welded (18) into one, welding firm. 3.操作泵的焊接座板(件9)应焊接在油柜操纵方便的位置上，然后将操作泵(件10)固定于焊接座板上。 Action pump in welded plates (part 9) should be welded on the oil tank manipulated conveniently situated and operating pump (part 10) on fixed on welding plates 4.将驱动器(件1)分别和上自闭阀(件5)以及下自闭阀(件17)连接起来，并用紧固螺钉（件20）旋紧， 驱动器与自闭阀按钮的间隙应保持不大于1mm为准，然后用油管（件16）和卡套接头（件11）将 操作泵和驱动器连接起来。 Will drive (pieces 1) respectively and Up self closing valve (pieces 5) and Under self closing valve (pieces 17) connection up, and tight solid screws (pieces 20) Rotary tight, drive and self closing valve button of gap should keep does not is greater than the 1mm for quasi, then with tubing (pieces 16) and cutting sleeve (pieces 11) will operations pump and drive connection up 5.油位计每1.2米长用一固定卡，将固定卡座(件7)调整至适当位置后，焊于油柜，用固定卡(件8)将 油位计固定。 Oil level gauge use fixed cards with each 1.2-meter, pulling the card (7) after the adjustment to the appropriate location, welded to the oil tank, with fixed cards (8) secures the oil level gauge. 6.油位计部分安装调整好后，将上、下驱动器的注油螺塞(件