DEK高级培训资料(240页).pptVIP

* * Objective 27 X Forcer (LMCF04A) has 5.5 – 6 ohms across phases. Y Forcer (LMCF06A) has 4 – 4.5 ohms across phases. Check clearance with shims run in diagnostics and ISCAN Health Check. * Highlight Voltages,Related cards etc as will be asked on next slide. * * * * Fault one: Place a small piece of insulating tape over the encoder strip (ie approx 2mm) This will cause the camera to make an abrupt jump. It should also throw off the camera ref position / fiducial location etc. Use the iSCAN in power off mode to detect the break in encoder feedback. Fault two: Rotate the 3-pin power conn