DEK印刷机-操作-编程-保养.docVIP

DEK 培訓 操作編 程 保 養 操作 操作?主畫面的識別 ?開關機 ?調程序 ?換鋼板 ?換頂針 ?加錫膏 ?安裝與清洗刮刀 ?換搽拭紙與溶劑 ?照辨識點 ?Mode印刷模式,有自動Auto,過板No Print,只刷一塊板Single,手動Step,共四種. ?Product程式名23C012 A .代表PCB料號K023C012,版本A. ?Temperature溫度 ?Humidity相對溼度 ?Cycle Time : 14.49 s:18.04 s ?其中14.49s為印刷上一塊PCB所花的時間(不包括等板時間. ?Front Print Speed前印刷速度 ?Rear Print Speed後印刷速度 主畫面的識別(3 ?Front Pressure前刮刀壓力 ?Rear Pressure後刮刀壓力 ?Separation Speed分離速度 ?Clean 1 Count Rate:4/10 ?搽拭頻率為每刷十塊PCB搽一次鋼板,現在已刷了四塊. ?Print Direction印刷方向,Reverse為向後印刷,Forward為向前印刷. 開機 將主電源開關順時針旋轉90度至垂直位置. 出現 按亮‘系統鍵’. Load Data Diagnost 關機 ?按Close SYSTEM ?按Yes ?出現Restart ?將主電源開關逆時針旋轉90度至水平位置. 調程序 ?在主畫面,按Setup ?按Load Data ?用Left ,Right ,Up ,Down 選擇程序名 ?按Load ?按Exit ,退回主菜單 Run Open Cover Paste Load Clean Screen Adjust Setup monitor maint Load Rebuild List Left Right Up Down Exit Mode Load Data Edit Data Setup Squeegee Change Screen Change Tooling Change Language Exit Load Rebuild List Left Right Up Down Exit Mode Load Data Edit Data Setup Squeegee Change Screen Change Tooling Change language Exit 取出鋼板 ?按Open Cover ?按Change Screen ?出現‘Open Front Cover and Remove Screen ’?打開前蓋?取出鋼板?關上前蓋 ?按亮‘系統鍵’ Run Open Cover Paste Load Clean Screen Adjust Setup monitor maint CHANGE SCREEN BOARD CLAMPS PRIME PAPER PRIME SOLVENT Exit 換上鋼板 ?按Open Cover ?打開前蓋?放入鋼板?蓋上前蓋 ?按亮‘系統鍵’?按Change Screen ?按Exit ,退回主菜單 Run Open Cover Paste Load Clean Screen Adjust Setup monitor maint CHANGE SCREEN BOARD CLAMPS PRIME PAPER PRIME SOLVENT Exit CHANGE SCREEN BOARD CLAMPS PRIME PAPER PRIME SOLVENT Exit 換頂針(1 ?在主畫面,按Setup ?按Change Tooling ?按Open Cover ?打開前蓋?放入頂針?放入鋼板?關上前蓋 ?按亮‘系統鍵’ Run Open Cover Paste Load Clean Screen Adjust Setup monitor maint Mode Load Data Edit Data Setup Squeegee Change Screen Change Tooling Change Language Exit Adjust Open Cover Home Cleaner Board Stop Full Width Load Width Print Height Exit 換頂針(2 ?按Home Cleaner ?按Exit ?按Change Screen ?按Exit ,退回主菜單 Adjust Open Cover Home Cleaner Board Stop Full Width Load Width Print Height Exit Adjust Open Cover Remove Cleaner Board Stop Full Width L