波音机械标准施工.ppt

管壁厚度 管路修理方法 You can repair tubes if you obey the permitted repair limits. When it is possible do the following: replace the damaged tube replace the damaged part with a tube splice repair the damaged tube with a fitting (if the damaged are is sufficiently small). completely remove all corrosion and treat affected surface area as described in the corrosion prevention manual. 管路修理限制 管路修理方案 A repair of a tube section can be in one of three groups. The groups have a relation to the location of the tube damage and the quantity of damage. The three groups are as follows: (a) Replace a tube end section that has a flareless end fitting you can move apart, with an assembled tube and fitting assembly (Figure 806). (b) Replace a tube center section that has a short damaged segment with a single union (Figure 805). (c) Replace a tube center section that has very much damage with an assembled tube and fitting assembly (Figure 809). 修理管路程序（Make a splice） 修理管路程序（Make a splice） (e) Measure all of the tube assembly length (L1) (see Fig. 806 and 809). (f) To find the necessary cutout length (L2) as shown on Figure 806 and 809, use the procedure given in Figure 810. (g) Remove the pressure from the systems where you will do the repairs. (h) Cut out the damaged tube (L2). Trim the tube ends as shown in Figure 804. 手工制作BACS12AP接头 To preset the sleeve by hand do the following: (a) Use the correct mandrel for the tube sleeve set fitting kit, SPL-1589 or the (Figure 819). (b) Lubricate the threads, sleeve shoulder, and conical seal area of the fitting with anti-scoring lubricant, D50174. Do not lubricate the tube. (c) Assemble the sleeve on the tube. Insert the tube into the tube sleeve set fitting kit, SPL-1589 union. Tighten the nut as shown in Figure 821. (d) If the ST879A preset tool is not available, you can preset the sleeves with a carbon steel union and nut as shown in procedure A or B of Figure 821. 手工制作BACS12AP接头 案例 2007年11月18日，B2388执行CA934/北京至浦东航班，在下降过程中，ECAM上出现绿系统低压警告信